Question about 1992 BMW 3 Series
BMW cylinder torque setting all models
According to my service manual as follows.
Cyl head to engine block (torx e12 M10 bolts)
Stage 1 30nm (22 ft – lb)
Stage 2 + 90 degrees
Stage 3 + 90 degrees
Cyl head to lower timing chain cover 10nm (89in – lb)
The tightening sequence is from inside to outside crossover as normal. Loosening sequence is from outside to inside crossover. Remember to set torque wrench at low setting and work gradually up through the whole sequence until you get the desired torque.
Posted on Aug 29, 2009
Fuel squirting into manifold while ignitions off could it be a faulty fuel pump or relay its causing the car to not start any ideas
Posted on Jul 18, 2011
I need the torque seeting for the camshafts on a bmw328i e36
Posted on Aug 29, 2010
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Jun 11, 2011 | 1997 BMW 318
Oct 05, 2010 | 1997 BMW 318
Jul 08, 2009 | 1996 BMW 318
Jun 16, 2009 | 1992 BMW 3 Series
Jun 13, 2009 | 1992 BMW 3 Series
Apr 04, 2009 | 1996 BMW 318
2,793 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: