Cars & Trucks Logo
Posted on Nov 09, 2010

How to remove the rear seat of a Honda Ridgeline 2010.

1 Answer

Anonymous

Level 1:

An expert who has achieved level 1.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 1 Answer
  • Posted on Feb 28, 2011
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Feb 28, 2011
Answers
1
Questions
0
Helped
6464
Points
6

1. Pull the plastic panels under the seat bottom straight forward to remove them.

2. Remove the six bolts (14mm) holding the seat and center seatbelt in place.

3. Pop the two small plastic covers at the top and behind the seat using a trim removal tool or screwdriver tip covered in masking tape.

4. Lift the seat straight upward.

5. Remove.

The Service Manual states a 35 ft lb torque and must be re-installed in a certain sequence for the 6 seat anchor bolts (not the seat belt bolts). When putting the rear seat back in install the bolts in this order. (1) center left (2) center right (3) left lower (4) right lower (5) left upper (6) right upper.

1 Related Answer

Anonymous

  • 1 Answer
  • Posted on Jun 23, 2011

SOURCE: Honda Ridgeline rear seat leg problem

honda sells that plastic pully wheel for $16. in metal now

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2006 Honda Ridgeline RTL. How to remove the folding seats please?

Question edited for clarity.
Question moved to model category.

Removing seats

https://www.google.com/search?q=2006+honda+ridgeline+rtl+remove+folding+rear+seat

Fuel pump replacement. You may be able to just replace the fuel level sender. There was a recall on the fuel pump relay.

https://www.google.com/search?q=2006+honda+ridgeline+rtl+fuel+gauge+sender+unit


0helpful
1answer

Remove rear seat from Honda Ridgeline 2006 ?


1. Pull the plastic panels off under the seat. pull them straight forward to remove them.
2. Remove the six bolts (14mm) holding the seat and center seatbelt in place.
3. Pop the two small plastic covers at the top and behind the seat using a trim removal tool or screwdriver. Cover the screwdriver with something so you don't damage anything.
4. Lift the seat straight upward and take it out
0helpful
1answer

How do I remove the rear seat of 2011 Honda Ridgeline?

It is bolted to the floor by two bolts or nuts on studs front and rear, there is likely plastic trim covers over the bolts. Disconnect any wiring under the seat before lifting out.
0helpful
1answer

Need to reset odometer because it reads a14

My A14 Timing Belt service experience - Honda Ridgeline Owners ...

www.ridgelineownersclub.com > ... > Under The Hood / Performance
Apr 30, 2011 - 11 posts - ‎5 authors With the the dreaded A14 MM light on, I quickly panicked at the thought of the cost. After much ... 2008 *Former Ridgeline Owner Dark Cherry Pearl ... 2006 Pilot EXL-RES in BSM. speedlever is .... code is On. HTML code is Off ... A14 parts nightmare
8 posts
Apr 21, 2015
DIY Valve Adjustment on 2006 Ridgeline w/photos
11 posts
Nov 25, 2012
Maintenance Reminder code A36
11 posts
May 10, 2010
a14 service minder problem
3 posts
Jan 12, 2010
More results from www.ridgelineownersclub.com
1helpful
1answer

How do you remove the "TRACK TRIM" from the front seat of my Honda Ridgeline.

check for screws or caps covering screws in the plastic trim.if there aren't any take a flashlight and look under the seat for clips that release the plastic, it may just pry off.
0helpful
1answer

How to remove front seats

The seats are simply bolted to the floor. You'll need to remove the track trim pieces to see them. 14mm socket to remove them. The wiring can be disconnected easier once the seat is loose and can be tilted backward.
0helpful
1answer

Seat bar not retracting

Typically there are plastic cable pulleys used in the seat retraction system that routinely fail. These have been replaced with metal ones by Honda, and are fairly cheap. Save yourself a ridiculous labor charge and go to www.ridgelineowersclub.com and search for seat - pulley - repair, etc. There are excellent descriptions on how to fix it. It will take about 30-45 min max. Make sure to replace BOTH pulleys for the rear seats. This forum is a priceless resource for Ridgeline owners. Honda Ridgeline Owners Club Forums
0helpful
1answer

How do you replace rear seat pulley on 2006 honda ridgeline

To replace the filter on your Honda CBR - Locate your air filter, usually found on top of the engine. On cars with carburetors it is in a round piece of metal about the size of a medium pizza; fuel-injected cars have square or rectangular air filter housings that may be off to the side of the engine. Unscrew or unclamp the top to the air filter housing. Lift out the air filter. It should be a round or rectangular filter made of paper or plastic, with a rubber rim.lightdeal
16helpful
5answers

Honda Ridgeline rear seat leg problem

honda now offers metal 9zinc) cable retractors for the rear seat legs thet are supposeed to retract automatically wher you forld the seaat up. About $8.00 each. You will need tow of them. one for each seat. atahe original ones were plastic so at least these are a better solution. The dealer printed out the instructions on how to repair this problem and the part numbers you will need to do so. Ask your local Honda dealer service tech for a copy of the Honda bullitin that was sent out about March 2011 on this issue. This bulliten is very helpfull. Mcgrath Honda in Elgin Ill. gave me a copy of it.
Not finding what you are looking for?

6,474 views

Ask a Question

Usually answered in minutes!

Top Honda Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...