1998 Dodge Intrepid Logo

Related Topics:

Posted on Jun 15, 2008

1998 intrepid check engine light

I have a 1998 intrepid with a check engine light on there two codes that came up 1494 and 1684 can you help me with this problem ?

  • Dougjy Aug 12, 2008

    My check engine light stays on all the time. The car runs smooth, the transmission changes smooth and the oil level is good and I just changed the oil in both the transmission and the engine. Any suggestions?.

×

1 Answer

N SIer

Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 14 Answers
  • Posted on Jul 22, 2008
 N SIer
Contributor
Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

Joined: Jul 21, 2008
Answers
14
Questions
1
Helped
2071
Points
30

1484 The catalyst seems to be overheating!
1684 The battery has been disconnected within the last 50 starts.

from what i have researched the 1684 is a common code that these vehicles give out..i even got one when i checked mine and i had never disconnected the battery before..so i wouldn't pay to much attention to that one...now the other code is a different story

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Can you check the trouble codes without a code reader on a 1998 dodge intrepid 2.7

open and close the ignition switch 3 times ending at an open switch check engine light should flash long flashes are tenths and short flashes are units example two long flashes and three short flashes is code 23.
0helpful
1answer

1998 dodge intrepid loss of power and chk eng light came on

Hi:Just one code there, or your descripotion is about two or mode fault codes; we will need exactly what code number is detected there.

You could find code description here: obd_codes.html

Hope this helps
0helpful
1answer

Loss of power.chek engine came on. did diag. test and said:heated cat.wec air sys. and acfridge

Hi there:Just one code there, or your descripotion is about two or mode fault codes; we will need exactly what code number is detected there.
You could find code description here: obd_codes.html
Hope this helps.
1helpful
1answer

My 1998 Dodge Intrepid is starting & then stalling only after a few seconds. The engine light came on, & the code was P1391. Any ideas?

That code is indicating an intermittant crank shaft or cam shaft sensor fault. Because the engine is starting then stalling, check to see if you have spark after the stall. If spark is still present, you are probobley looking at a cam sensor circuit issue. The cam sensor controls the fuel injector pulse. If the cam sensor fails on a chrysler product, the fuel injectors will not function.
0helpful
1answer

Check engine light is on

unhook and rehookup the battery this will reset the computer if the light comes on again you should take it to an auto parts store to determine what code it is displaying to narrow the problem down good luck
2helpful
2answers

1998 dodge intrepid battery light and heck engine light on. only 10 volts coming out of alternator. changed alternator, battery and pcm module. still has lights.

I have a 2000 dodge intrepid- the battery light was coming on and off for a few days and then the car just died. We checked and replaced the alternator and the car started right up (we did charge the battery for an hour before starting the car) but when you take the charger off the battery the car slowly dies. Please help?
0helpful
1answer

Engine light is on

May just need to reset computter.Low coolant can set engine light on,Most local parts houses will check code and restet for you no charge.
0helpful
1answer

1998 Intrepid random misfire

I have a 98 dodge intrepid with a 2.7. My car would run fine at times and then all of a sudden start to miss badly and the valves would rattle. The mechanic changed the cam shaft sensor and now it runs very well.
0helpful
2answers

98 Dodge Intrepid Check Engine light

Try disconnecting your battery for a approx 30 seconds. take neg. off first & put it on last.
Not finding what you are looking for?

368 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...