How do you reset the oil life light after the oil has been changed in 2009 Honda Pilot? My oil was already changed, but the "wrench" shaped light comes on every time I start my engine.

1. Edit Step 15 ¶ When it's time to change the oilin your Civic, the maintenance light (orange wrench) will appear on your dash, as well as a B1 message, showing an oil life of 15% or less. To reset the Oil Life % gauge, press and hold the SEL/RESET button for about 10 seconds until the Oil Life message begins to flash.

2006-2011 Honda Civic Oil Change (1.8L) - iFixit

https://www.ifixit.com/Guide/2006-2011+Honda+Civic+Oil.../6446 iFixit

Reset oil service light Honda Pilot. From years: 2003, 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012.
How do you reset oil service light Honda Pilot. From years: 2003, 2004, 2005.

1. Turn off the engine. Press and hold the SELECT/RESET button in the instrument panel and turn the ignition switch to run (one position before starting).
2. Hold the button for at least 10 seconds, until the indicator resets.
3. Turn the ignition off and then start the engine to verify the indicator has been reset.

How to reset oil service light Honda Pilot. From years: 2006, 2007, 2008, 2009, 2010, 2011, 2012.
Resetting the Engine Oil Life Display if maintenance service is done by someone other than your dealer, reset the maintenance minder as
follows:

1. Turn the ignition switch to the ON (II) position.
2. Press the select/reset knob repeatedly until the engine oil life is displayed.
3. Press the select/reset knob for about 10 seconds. The engine oil life and the maintenance item code(s) will blink.
4. Press the select/reset knob for another 5 seconds. The maintenance item code(s) will disappear, and the engine oil life will reset to 100.

All information is taken from the Honda Pilot owners manual.

Here is a link to a You Tube video that shows you.

Oil life reset procedure Honda Odyssey 2005 2010 3 5L turn off light Pilot...

That is just a Gadget for oil & cabin filter, just forget it
or reset them to 100%
They are not tied to the vehicles systems

Change your oil every 4,000 miles tops & use
Full Syn 5W-20 as it calls for (Lincoln L/S)

The Honda you Scan for codes-you already know that

The wrench light indicator is a reminder that you are do for your next service(For example:oil change, air filter change, trans fluid change and so on) base on the miles on your car. A lot of people just get a oil change and have the light reset. If you read your car manual book it will tell you what service you need to do. Note: light come on every 3,000 miles and you can reset any time you want.
How to reset light:
1.with headlight off, turn the key on. Do not start the car.
2. On the left side of th dash below the heat vent there is a button that says "sel reset". push that button until you see "oil life" and a percent on the gauge display screen.
3.Now while on the oil life display, push and hold the "sel reset" button until screen start to flash. you might have to hold for 45sec.
4.when the screen start flashing, release button and hold it down again. might have to hold for about 45sec.

if you did it right the percent should go up to 100% and the wrench light should go out.

It is probably telling you that the oil needs changing soon. The wrench is telling you it needs service and the 15% is probably stating you have 15% of life in the oil left, with 0% being the oil has to be changed. Most newer cars recommend the oil is changed every 3000 mi or 3 mo.

Is the oil life low? If so scroll up the oil life and hold down the RESET knob until it goes out. If the oil life is high, then service is needed.

yes change it to

From page 232 in the 2007 Honda Pilot Owners Manual.

1. Turn the ignition ON.
2. Press the Select/Reset knob until the engine oil life indicator is displayed.
3. Press the Select/Reset knob for more than 10 seconds. The engine oil life and maintenance item code(s) will blink.
4. Press the Select/Reset knob for another 5 seconds. The maintenance item code(s) will disappear, and the engine oil life will reset to "100".

display info and then hold reset for 16seconds it will ask oil life reset 100 pecent yes or no press yes