Where is the flasher relay on a 1995 Saturn SW1? Don't see it in the instrument panel fuse box in the console.

Question edited for a lot more clarity.
Question moved to model category.

It might be the flasher relay and it might be the horn relay although horns tend to seize up through lack of use. the flasher relay is is separate to the Hazards relay which is often part of the switch.

https://www.google.com/search?q=1997+chevy+lumina+flasher+relay+location

Chevrolet Lumina (1997) - fuse box diagram - Auto Genius

https://www.autogenius.info > chevrolet-lumina-1997-f...

Jan 1, 2018 - Fuse, Description. 1, CIGAR LIGHTER - Instrument Panel and Console Cigar Lighter. 4, WAC- WAC Control Assembly Solenoid Box, Mix Motor, ...

Chevrolet Lumina (1995-2001) fuses and relays

https://fuse-box.info > chevrolet > chevrolet-lumina-19...

Here you will find fuse box diagrams of Chevrolet Lumina 1995, 1996, 1997, 1998, 1999, 2000 and 2001, get information about the location of the fuse panels ...

Easiest way though https://www.google.com/search?q=auto+electrician+near+me

..

Question edited for clarity.
Question moved to model category.

Fuse 33
ABS - Electronic Brake Control Module (EBCM), ABS Relay

Chevrolet Lumina (1995) - fuse box diagram - Auto Genius

https://www.autogenius.info > chevrolet-lumina-1995-f...
Jan 1, 2018 - Fuse, Description. 1, CIGAR LIGHTER - Instrument Panel and Console Cigar Lighter. 5, HAZARD FLASHER. 10, I/P ELECTRONICS BATTERY FEED ...
..

Flasher Module

https://www.google.com/search?q=1995+buick+regal+turn+signal+flasher+location

Buick Regal (1995) - fuse box diagram - Auto Genius

https://www.autogenius.info > buick-regal-1995-fuse-b...
Jan 16, 2017 - Buick Regal (1995) - fuse box diagram. Year of production: 1995. Instrument Panel Fuse Block. Some fuses are located in a fuse block on the ...

Fuse Box Diagram Buick

https://fuse-box.info > Home > Buick
Fuse box diagram (location and assignment of electrical fuses and relays) for Buick Regal (1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004). Buick Regal (2011-

Instrument panel fuse box,-- The instrument panel fuse block is located on the
passenger's side of the instrument panel. Turn and hazzards are in this fuse box. If no turn signals, it may be a bad flasher unit or relay. Good-Day! The relays are in under hood fuse box.

An electronic combination turn signal and emergency warning flasher is attached to the lower left instrument panel reinforcement above the fuse panel.
The turn signal unit is located on the LH side of the instrument panel. The combination turn signal and hazard flasher can be removed by pressing the plastic retaining clip and pulling straight rearward. One phillips® head or regular screw has to be removed from the retaining bracket. It's square not round !

Hope this helps!

The turn signal flasher is located in the IPJB. Check the label on the back of the trim panel for the exact location on your vehicle.

To replace the flasher, simply grasp and pull it straight out. Align the contacts on the replacement flasher with its mounting position in the IPJB, then push it in place.

Instrument Panel Junction Block (IPJB)

1. Remove the lower right trim panel from the instrument panel center column. Separate the Velcro™ fastener at the bottom of the trim panel and carefully unsnap the top corners of the panel from the fasteners.
   
2. Remove the applicable fuse or relay from the IPJB, based on the identification label located on the back of the trim panel. A plastic puller is also located on the trim panel to ease fuse removal.
   
3. Installation is the reverse of removal
   

// // 0) preLoad.src = ctl00_cphLeft_chRepairTreeNav_tvTOC_ImageArray[i]; } ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.lastIndex = 33; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.populateLog = theForm.elements['ctl00_cphLeft_chRepairTreeNav_tvTOC_PopulateLog']; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.treeViewID = 'ctl00$cphLeft$chRepairTreeNav$tvTOC'; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.name = 'ctl00_cphLeft_chRepairTreeNav_tvTOC_Data'; //]]>

From the 1997 Mercury Grand Marquis 4.6L SFI 8cyl repair manual, the Flasher is located behind left side of instrument panel. The turn signal and emergency flashers are attached to the interior fuse panel. They are replaced in the same manner as the fuses and circuit breakers.



Fig. 6: 1995-97 models interior fuse box locations (click for zoom)

Hope helps (remember rated this).

Check the FLASHER, also can review the Fuses, located inside the passenger compartment, under the drivers-side of the instrument panel.

Both the turn signal flasher and the hazard warning flasher are mounted on the fuse panel on the truck. To gain access to the fuse panel, remove the cover from the lower edge of the instrument panel below the steering column. First remove the two fasteners from the lower edge of the cover. Then pull the cover downward until the spring clips disengage from the instrument panel.

The turn signal flasher unit is mounted on the front of the fuse panel, and the hazard warning flasher is mounted on the rear of the fuse panel.




To access the fuses, remove the fuse panel cover. Note the spare fuses (A) and provided fuse puller tool




Fuse panel and power distribution box identification for 1995-99 Explorer/Mountaineer models-Part 1




Fuse panel and power distribution box identification for 1995-99 Explorer/Mountaineer models-Part 2




Fuse panel and power distribution box identification for 1995-99 Explorer/Mountaineer models-Part 3


Power Distribution Box
Located under the hood, in the engine compartment. It houses the fuses and relays for most of the under hood components which are not controlled by a dash mounted switch (such as the alternator, fuel pump, ECM, etc.). The fuses and relays are replaced in the same manner as the fuse panel inside the vehicle. The power distribution box cover is hinged on one end and utilizes a retaining latch on the other. Simply release the latch and lift the cover up to gain access to the fuses and relays.

Hope helped with this; remember rated this help. Good luck.

located under the instrument panel to the left of the steering column. The fuse block should be visible from underneath the steering column, near the pedal bracket.


Some models may use an underhood fuse/relay panel


If the panel is not visible, check for a removable compartment door or trim panel which may used on later models to hide the block. This panel is usually located on the left end of the instrument panel.
The convenience center is located just below the instrument panel on the drivers side. It contains individual relays such as the seat belt and ignition key alarm, and flasher.
On newer model vehicles there is an underhood fuse/relay center contains both mini and maxi fuses, as well as some relays.

Replacement The turn signal and hazard flasher units are usually located in the convenience center located just below the instrument panel on the drivers side. Replace the flasher by unplugging the old one and plugging in the new one. Confirm proper flasher operation.

Replacement

1. Access the fuse panel from the left of the steering column.
2. Locate the blown fuse and pull out. DO NOT TWIST.
3. Take note of the ampre number written on the top of the fuse. To install:
   
4. Push a new fuse of the same ampre into the receptacle, making sure the contact is being made on both sides of the fuse.

LOCATIONS Headlights and Highbeam Indicator

• One 18 amp circuit breaker (22 amp in 1987 vehicles) incorporated in the lighting switch.

Front and Rear Marker, Side Parking, Rear and License Lamps

• One 15 amp circuit breaker incorporated in the lighting switch.

Windshield Wiper

• One 4 1⁄2 amp circuit breaker located in the windshield wiper switch.

Power Windows

• Two 20 amp circuit breakers located in the starter relay and the fuse block.

Power Seats and Power Door Locks

• One 20 amp circuit breaker located in the fuse block.

Hazard Flasher REMOVAL & INSTALLATION NOTE: The hazard warning flasher is located on the rear side of the fuse panel.

1. Locate the hazard flasher in the fuse panel.
2. Pull the flasher out. DO NOT TWIST. To install:
   
3. Push new flasher into place making sure a good contact is made with both terminals.
4. Test flasher to make sure they function properly.

Various Relays LOCATION Cooling Fan Controller

• Located behind the left side of the instrument panel.

Cooling Fan Controller Module

• Located behind the right side of the instrument panel.

Cooling Fan Relay

• Located in the air conditioning cooling fan control module.

Electronic Control Assembly

• Located under the left side of the instrument panel.

Electronic Engine Control Power Relay

• Located behind the glove box on the right side of the instrument panel.

Fuel Pump Relay

• Located behind the glove box.

Horn Relay

• Located in the fuse block.

Fig. 1: Main fuse box located on driver's side to the left of the steering wheel, above the brake pedal


This is the best info I could find....I hope this helps ya!