I have 2002 infinity I35 and the blower motor stop working ,I took out the blower motor to make sure was good. YES the blower motor still working .the only think I really don't know how to check is Blower Motor Resistor..some one told me if the Blower Motor Resistor go bad the blower will not work ....please hope you can help me thank you for you time

The most common reasons an INFINITI I35 heater isn't working are a broken heater blower motor, a problem with the thermostat, or a failed heater blower motor resistor.

INFINITI I35 Heater Is Not Working - RepairPal.com

..

What code did it throw?

This may be the engine stabilizer mount motor. It can get stuck, and run all night. I had this happen recently. You can pull the fuse, but the car will not run as smoothly until you replace the stabilizer.

your i35 is a maxima

check blower motor resistor common problem on most vehicles..

Make sure that the radiator fan is going off like it is suppose too. Also, some vehicles have a shut off on the water inlet hose to by-pass the heater core for the A/C when it is running in the summer. This could be malfunctioning.

My 2002 I35 has the blower fuse under the hood in the fuse box in the engine compartment. The fuse box cover has the "key" or description of which fuse is which. If the blower fuse is bad and you replace it, only to have the fuse burn again then I would check the blower resistors that are located behind the glove box. Very common for one of these resistors to go bad causing only low speed operation of fan. Burns the fuse when you try to operate the fan on the higher speeds. Good Luck

Yes you can use Premium Unleaded Gasoline in your 2004 Infinity I35. Infinity actually recommends Premium grade gasoline for your car!

Doesn't sound like the brake lines were bled properly. Many times after pad and rotor installation if the lines are bled correctly you will have to pump them initially after the repair for a couple of minutes until the pressure is built back up. Also check the master cylinder and make sure fluid level is ok.

six screws hold the glove box two at bottom four at the inside when u open the box after the screws are out pull on the box to remove and three hold the blower motor.its not hard at all.