At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
as for your door locks, your key fob may have been misprogrammed when you removed the battery. refer to owners manual to reset your locking options on your key fobs. as fot the door open light, try spraying a silicone based product into the inside door lock mechanisms. silicone spray is much better than wd 40.
The brake lights have power with the key off, so you have just one thing that is causing this, a defective brake light switch. The brake light switch is located at the top of the arm the brake pedal is attached to under the dash, you will need to remove the lower panel under the dash to see it. The part is cheap and requires little skill to replace. Below is a picture of the part.
The diodes in your alternator are bad. they are allowing bleedback of voltage. you will eventually need to replace it as it will drain your battery. Not a big deal until it leaves you stranded but the battery light in your dash does not use alot of power.
Add Duplicate Key (PK3 or PK3+ key)
1. Insert an existing key into the ignition cylinder. 2. Turn the ignition cylinder to ON (RUN) and back to OFF. 3. Remove the existing key and, within fifteen seconds, insert the new key and turn it to ON (RUN). 4. The security light will light up for two seconds to indicate success in programming the key into the vehicle. Originate New Master Key (PK3 or PK3+ key)
1. Insert new key into ignition cylinder and turn it to the ON (RUN) position. The security light on the dash will illuminate and stay on for ten minutes. 2. When the security light goes out, you have one minute to start the next step. Turn the ignition cylinder to OFF and then back to the ON (RUN) position. The security light on the dash will illuminate and stay on for ten more minutes. 3. When the security light goes out, you have one minute to start the next step. Turn the ignition cylinder to OFF and then back on the ON (RUN) position. The security light on the dash will illuminate and stay on for ten more minutes. 4. After the security light has gone off the third time, the key has been programmed into the vehicle’s computer and will operate the car. It has replaced ALL the previous electronic key codes and is the ONLY key programmed into the vehicle’s computer.
Add Duplicate Key (PK3 or PK3+ key)
1. Insert an existing key into the ignition cylinder. 2. Turn the ignition cylinder to ON (RUN) and back to OFF. 3. Remove the existing key and, within fifteen seconds, insert the new key and turn it to ON (RUN). 4. The security light will light up for two seconds to indicate success in programming the key into the vehicle.
Sounds like a bad ignition switch, usually in the steering column under the plastic, it should be only around $40. try AutoZone if it doesn't hellp they're good about returns
×