On the bottom side of the car under the fog light area there will be an inspection cover. it is held in place by two plastic trim clips. they will have what looks like a philips head on the screw. remove both of these then pull out the retainer (they are set up like a dry wall anchor). pull back the cover and unplug the bulb. twist the bulb counter clock wise to remove. install in reverse order.
Good luck!!
EJ
SOURCE: High mount brake light
Hi i would take it to the dealer. they are really hard to do and thay take me almost and hour.
SOURCE: My 2006 Hyundai Sonata's brake lights are not working
try the brakelight switch, it is right near the pedal above the footpad
SOURCE: replace fog light bulb for 2006 Honda Odyssey
Touring Model
Use a wrench to remove the mounting bolt from the underbody through the hole in the splash shield.
Remove the fog light assembly from the bumper by pulling its inner edge first, then the whole assembly out of the bumper.
Remove the electrical connector from the bulb by pushing on the tab and pulling the connector down.
Remove the bulb from the fog light assembly by turning it one quarter turn counterclockwise.
Push the electrical connector onto the new bulb.
Turn on the fog lights to test the new bulb.
Reinstall the fog light assembly into the bumper. Tighten the mounting bolt.
Insert the new bulb into the assembly and turn it one-quarter turn clockwise to lock it in place.
Hope this helps you.
SOURCE: how do you replace the fog light bulbs on a 2007
Look under the bumper and you will see two large phillips head screws right in front of the wheels. Take these two screws out and bend/move the plastice piece out of the way. Now you can easily get to the bulb. There is a cap that twists off that protects the wires and back of the bulb. Twist this off and then remove the plug portion from the back of the bulb. The bulb then turns 1/4 to 1/2 revolution to loosen and remove. Reverse steps for installation.
2,588 views
Usually answered in minutes!
×