Nissan sentra gxe 03 rear wheel hub bearing problem

link on relay
https://www.justanswer.com/nissan/2sn3q-2003-nissan-sentra-gxe-relays-the-hood-compressor-push-button.html
two fuse boxes link
https://www.youtube.com/watch?v=yIB4rlYwpjo
owners manual 03 sentra
https://justgivemethedamnmanual.com/nissan/2003-nissan-sentra-owners-manual/
Hope something here can help you

replacing bearing involves removing axle your not replacing a hub but tearing apart axle 99 04 F250 Sterling Rear axle bearing replacement Pt 2 2006 Ford F250 rear hub axle seal replacement F250 Rear Brakes Axle Hub Removal Install 03 07 Powerstroke

Located in the passenger side. Under the dashboard

The 1996 Sentra sedan is available in four models - (Base) Sentra, XE, GXE and GLE. The Sentra remaines unchanged. The Sentra features minor updated interior and exterior styling. Safety features include front and rear crumple zones, side impact beams, energy-absorbing steering column, child safety door locks and driver and passenger-side air bags. All models are equipped with five-speed manual transmission, four-wheel independent suspension, bucket seats, cup holders, tilt steering wheel.---------------------------------------------------------------------------------------
D900 CANSCAN OBD2

Go to YOU TUBE and put in replacing wheel bearing hubs for
nissan altima & watch

There is a lot to see even if on a different vehicle

I doubt you have the tools to do the job

did u know u should be able to pound out the stud and replace it?

anyway.. remove tire, remove brake calliper, remove rotor, remove the cap in the middle of the wheel bearing (hub) and remove the big nut.

there is 3 or 4 bolts behind the hub that hold the wheel bearing (hub) on, remove those. Get a hammer and a chisel and separate the wheel bearing from the rest of the housing.

Its on steering wheel.

Raise vehicle, remove wheel, remove brake caliper, remove brake rotor remove steering knuckle by disconnecting the tie rod, ball joint, and strut. press out hub, remove snap rings press out bearing. Reassemble in reverse order.

rdfairfield: if you are asking about the rear? Yes, that is the only way the part comes and is manufactured. It is a hub and bearing assembly..

Yes