To reset (calibrate) the system: The tire inflation
monitor system can be reset two ways. With the
ignition position at ON, pull the interior lamps
control to the ON and OFF settings three times.
It can also be reset through the radio using the
following steps:
1. Turn the ignition to ACC or ON and turn the
radio off.
2. Press and hold the TUNE DISP button on the radio for
at least five seconds until SETTINGS is displayed.
3. Press the SEEK PTYPE up or down arrow to scroll
through the main menu.
4. Scroll until TIRE MON appears on the display.
5. Press the 1 PREV or 2 NEXT button to enter the
submenu. RESET will be displayed.
6. Press the TUNE DISP button to reset. A chime will
be heard to verify the new setting and DONE will be
displayed for one second.
7. Once the monitor has been reset, scroll until EXIT
appears on the display.
8. Press the DISP button to exit programming. A chime
will be heard to verify exit.
The system completes the calibration process
during driving.
The system normally takes 15 to 20 minutes of driving
in each of three speed ranges to “learn” tire pressures.
The speed ranges are 15 to 40 mph (25 to 65 km/h),
40 to 65 mph (65 to 105 km/h) and above 65 mph
(105 km/h). When learning is complete, the system
will alert you after two to eight minutes if a tire is 12 psi
(83 kPa) different from the other three tires. Detection
thresholds may be higher and detection times may be
longer on rough roads, curves and at high speeds. The
system is not capable of detection at speeds greater than
70 mph (110 km/h).
If you don't have the manual, you can get it in PDF format for FREE from www.mygmlink.com
GoodLuck And PEACE
Is there an after market audible tire pressure warning system That I can add to my HHRSS oem sytem?
SOURCE: low tire pressure idiot light
Your nissan also has a tire monitor on your spare tire if your spare has low pressure and the other 4 tires have correct pressure the light will stay on . after you ajust the spare also the light should go away.
SOURCE: LOW TIRE PRESSURE WARNING LIGHT
Turn ignition to run position,go to fuse panel right hand of vehicle,push and hold reset button for 5 seconds,low pressure light will flash 3 times,start car it should turn off the low pressure light.
SOURCE: Tire pressure light is on
If you have the spare on it doesen't have the sensor in it and the light will stay on. If the spare is not on then you have a bad sensor in one of the wheels.
SOURCE: How do you reset a low tire pressure warning on a 2008 Jetta?
Reset the tire pressure warning, same as you would any service issue. Insert key in ignition, hold wrench button and min button, then start engine.
SOURCE: need to disable tire pressure warning light. Air pressure normal
You cannot "disable" the TPWS. Also, when you replace sensors, they need to be programmed to the TPWS computer.
2,227 views
Usually answered in minutes!
×