Hello,
Most headlights these days are replaced from the backside of the headlight. It is a replaceable small bulg that is held into the plastic reflector of the heah light.
To replace the bulb you must disconnect the connector on the bulb, then turn the bulb a little and it comes out of the headlight reflector. When replaceing be care full to not touch the cgalss of the new bulb. The oil from your fingers will cause the bulb to run hot and burn out early.
Now here is an easier solution, go to Autozone and ask if they would help you install a couple new bulbs..I bet they will help for free.
Good luck
Inspect/Replace-I don't think that removing the bumper is necessary.
There can be slight variations in procedure from one model to another when replacing headlights. For instance, on some models the turn signal light assembly must be removed before the headlight can be replaced. Overall, however, the procedure does not differ much from the following typical instructions.
Make sure the replacement bulb is the same type and part number as the one that is being replaced.
Comparing the old and ther replacement headlamps.
To Replace:
400 views
Usually answered in minutes!
×