SOURCE: looking for a diagram on removing and replacing
The Neutral Safety Switch function is controlled by the Transaxle Range Sensor (TRS). This Switch is Located ON the Transmission with Plug Facing UP and it is on the Bumper / Driver Side of the Transmission You Simply UNPLUG Electrical Connecter, And then the Unit Screws Out of Transmission Counterclock Wise, Install REVERSE Procedure.
NOTE: Be sure to have a DRAIN PAN Under your Work Area as there May be SOME Fluid Drainage When Switch is Removed, Swap them Fast if Fluid Comes out Fast so as NOT to have to Replace A Bunch of Trans. Fluid.
SOURCE: Where is the neutral safety switch located on 1998 Town & Country
THE NEITRAL SAFTEY IS LOCATED ON THE DRIVERS SIDE OF THE TRANSMISSION WHERE THE SHIFTING LINKAGE HOOKS TO AN ELECTRICAL SWITCH THIS SWITCH CONTROLS ALL FUNCTIONS
REVERSE LTS, NEUTRAL SAFETY AND OTHER ITEMS
SOURCE: 2002 Chrysler Town and Country
Ok, i'm assuming your replacing them, there is an oval rubber stopper on the backside of the rotor, in the backing plate, located near the bottom. it will tighten or loosen the e-brake shoes inside the rotor, loosen them all the way off, then get a big hammer and give them a really good smack, be carefull not to damage the wheel studs, if your reusing them hit on the hat of the rotor, if replacing you can hit right on the rotor face.
Use some antiseize on the hub before installin your new rotors, and don't forget to readjust your
e-brake and reinstall the rubber plug
SOURCE: How do you take off driver side door panel on 2002 T@C Chrysler van?
Take off whatever screws you can find. I believe there are 2 or 3 along the botttom, 1 in the pull cup and there may be another one somewhere around the switches. Then stick a flatblade screwdriver up into the bottom between the plastic and sheet metal and pry outwards. Feel around for a plastic clip and try to pry right next to it if you can to avoid breaking the panel. Once you've got the bottom loose, just reach in there and pull the whole thing away from the door. There's gonna be a few electrical connectors and a rod that goes to the interior release handle. Don't forget to hook that thing back up when you put it back together. Those plastic clips go all the way around the door and you're gonna break a few of them. Don't sweat it though. They only cost a couple of bucks a piece and generally don't need ALL of them anyway.
SOURCE: 2003 Chrysler Town and Country Van. Radio has a
check antenna connection at rear of radio and window antenna for damage or breaks
3,694 views
Usually answered in minutes!
×