REMOVAL & INSTALLATION
Fig. 3: Insert the crankshaft sensor tool into theneed to replace the crankshaft - 89634g75.giflancer
SOURCE: Replace crankshaft position sensor
Remove the left front wheel....(drivers side). Remove all accessory belts. Remove the crankshaft shaft pulley.......remove the plastic lower timing belt cover.....and there it is! It is mounted with one bolt.
The wiring runs down the right side of the timing cover while looking at it from the drivers side of the car.
Testimonial: "I ended up having my mechanic do the work. He did say he had to move all those parts to get to the sensor. "
SOURCE: buick regal 1996 crankshaft position sensor
IF THE CRANK SENSOR GOES BAD ON THAT ENGINE THE CAR WILL STOP RUNNING OR NOT START IF TRYING TO START IT. NEED THE CODE INFO TO HELP YOU FURTHER. TRY GOING TO ADVANCED TO GET THEM TO READ THE CODE-THEY DO THIS FOR FREE.
SOURCE: Need to replace both crankshaft position sensors 2001 Cadillac
4.6 the twocrankshaft position sensors are located on the front of the block just above and to the left of the oil filter. not hard to replace.
SOURCE: location of crankshaft position sensor Jeep grand cherokee 1997
left rear of engine block,on transmission bell housing.best way from top under brake booster use a wrench,
SOURCE: crankshaft position sensor location
1990 Chevrolet Cavalier 2.2L TBI 4cyl
The Crankshaft Position Sensor is located under hood, center, rear engine area, below ingnition
coil pack and DIS module, mounted in engine block.
Fig. 1: View of the CKP sensor-to-crankshaft reluctor relationship
Crankshaft Position (CKP) Sensor
A
magnetic crankshaft sensor (Hall Effect switch) is used which is
remotely mounted on the opposite side of the engine from the DIS/IC
module. The sensor protrudes in to the engine block, within about 0.050
in. (1.27mm) of the crankshaft reluctor.
I really hope help you wuth this (rated this help). have a nice day, good luck.
Testimonial: "Awesome. Thanks."
?€¢
Engine control module (ECM) replacement
?€¢
Crankshaft damper replacement
?€¢
Crankshaft replacement
?€¢
CKP sensor replacement
?€¢
Any engine repairs which disturb the crankshaft to CKP sensor relationship
Important: The scan tool monitors certain component signals to determine if all the conditions are met to continue with the CKP system variation learn procedure. The scan tool only displays the condition that inhibits the procedure. The scan tool monitors the following components:
?€¢
CKP sensor activity--If there is a CKP sensor condition, refer to the applicable DTC that set.
?€¢
Camshaft position (CMP) signal activity--If there is a CMP signal condition, refer to the applicable DTC that set.
?€¢
Engine coolant temperature (ECT)--If the engine coolant temperature is not warm enough, idle the engine until the engine coolant temperature reaches the correct temperature.
•
How to test Crankshaft Position CKP Sensor?
---------------
Crankshaft Position Sensor Operation?
----------------
Replace Camshaft position sensor and Crankshaft Position Sensor?
http://technoanswers.blogspot.in/2012/06/2005-dodge-durango-replace-camshaft.html
----------
GMC Crankshaft Position (CKP) Sensor
Replacing?
http://schematicsdiagram.blogspot.com/2011/12/gmc-crankshaft-position-ckp-sensor.html
------------
These details will help.
Thanks.
1,479 views
Usually answered in minutes!
×