SOURCE: No Start, No Spark, for Grand Caravan 3.8L
we get remans bad out of the box......... good luck
SOURCE: 1997 Dodge Intrepid cranks over won't fire
well first i can tell you to check your grounds from the battery for corrosion , it can be inside the cables also. next check out all the work you just did, make sure all electrical connections are tight, plug wires etc, any thing you touched.do the lights work fine when you try to turn it over? It could be alternator. if it turns the crank then it has to be an electrical problem. i will give you more ideas when they come to me.
SOURCE: Hi, I get a P0305 diagnostic code on my 2002 Dodge
It is a miss fire on number 5,it could be a bad spark plug,or boot on the coil to spark plug,do a spark plug change out .
I have a problem with a 1999 Dodge Intrepid 2.7. Looking for some help or suggestions.
Problem: I only have a spark from the #2 coil.
Background:
Vehicle purchased from an Auction and would not start. The vehicle would only backfire. When I removed the valve covers I found that one of the rocker arms had popped out. I replace the heads with heads from a 2001 Intrepid 2.7. I used the cams, primary and secondary timing chains from the 1999 heads. Not sure if I used the original primary (left) cam sprocket from the 1999 or one I purchased in a kit from a Dodge dealership. I tried to use the new primary timing chain but it was not the same. The replacement heads were surfaced and a new head gasket was used. When I tried to start the vehicle it had no spark. The vehicle had set at several locations and parts may have been removed or changed.
Solutions Tried:
I tried 4 ASD relays with no effect. I then tested all 4 on a 2002 Intrepid 2.7 that runs and all worked. I then discovered that the Crank PS has missing. I replaced the Crank PS with one from a 2002 Intrepid 2.7 with no effect. I then replaced the Crank PS with a Crank PS from a 1999 Intrepid 2.7 and got a spark at the #2 coil only. I then replaced the PCM and TCM from the same 1999 Intrepid I got the Crank PS from and still only have spark from #2 coil. I then changed the Cam PS, still spark only from #2 coil. I have tried several coil packs on connector #2 and all have spark. Each coil pack that sparks on #2 will not spark on any other connector. Spark from #2 coil is weak.
I then replaced the wire harness from the PCM to the coils and fuel injectors and still only have spark from the #2 coil. What am I missing? Any suggestions, advice or related information will be greatly appreciated!
Thanks!
Keith P. Richardson
404-606-0728
97 views
Usually answered in minutes!
×