The front mounts support the engine at each side (passenger and driver side of the engine block.
These supports are made of resilient rubber.
REMOVAL
(1) Disconnect negative cable from battery.
(2) Raise the vehicle
(3) Support the engine using a block of wood between the oil pan and floor jack so you dont dent the oil pan.
(4) Remove the nut from the through bolt but DO NOT remove the through bolt.
(5) Remove the retaining bolts and nuts from the
support cushions
(6) Remove the through bolt.
(7) Remove the support cushions.
Transmission mount (aka rear engine mount)
A resilient rubber cushion supports the transmission
at the rear between the transmission extension
housing and the rear support crossmember or skid
plate.
REMOVAL
(1) Disconnect negative cable from battery.
(2) Raise the vehicle and support the transmission.
(3) Remove the nuts holding the support cushion
to the crossmember
(4) remove the crossmember (sometimes you dont have to completely remove it but its easier if you do)
5. Remove the tranny mount
You have sveral mounts to motor mounts both sides then you have tranny mounts
The engine mounts are located about the middle of the block on the side of the engine. The only other mount is located under transmission.
515 views
Usually answered in minutes!
×