Headlight Adjusting Screw Operation:Used to adjust headlight beams up or down and left or right, it's located above and to the side of light behind the headlight retainer
SOURCE: 2003 volvo s60, how do i adjust headlights
The adjustment screws/nuts should be located either on the top of the headlamp assembly,
behind the headlamp assembly, or near the frame rail by the radiator
support.
You will have vertical adjustment screws for each independent beam
(separate highs and separate lows, but will be same screw if highs and
lows are the same bulb). You may also have additional horizontal
adjustment screws as well
Park
your car on a level ground 30 feet from a wall and measure the height
from the ground to the bulb and mark on a wall (do this for highs beams
and low beams if the bulbs are separate, if highs and lows are the same
bulb, only do it for the lows)
For Low Beams: If the headlights read VOR, then
aim the brightest part or cutoff part just below the mark on the wall.
If it says VOL or nothing, aim them 2 inches below the mark on the wall.
For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.
SOURCE: adjusting headlights volvo s60 2002
There is 2 white 6mm adjustmentbolts on the backside of the headlight
SOURCE: how do I adjust the headlights on a 01 Volvo s60
on the s80 in between the bulbs there will be the motors housed in a black box with an electric connection, above and part of this box there is an 8mm plastic nut, this aim up and down.
happy days
SOURCE: Electrical Connector burnt on headlight. Can connector be replaced?
cut the wire at bulb install female wire connector
5,134 views
Usually answered in minutes!
×