Oxygen sensors are always numbered like this:
Bank 1 sensor 1
Bank 2 sensor 1
Bank 1 sensor 2
Bank 2 sensor 2
Some manufacturers use a kind of shorthand that reads different, but means the same thing:
Sensor 1/1 or O2s 1/1
Sensor 2/1 or O2s 2/1
Sensor 1/2 or O2s 1/2
Sensor 2/2 or O2s 2/2
Bank 1 is always the side of the engine where cylinder number 1 is located and, of coarse, Bank 2 is the opposite side.
On a 4 cylinder engine, there is only 1 bank and it is always referred to as Bank 1.
Sensor 1 is always the upstream sensor (The one located BEFORE the catalytic converter)
Sensor 2 is always the downstream sensor (the one that is located AFTER the catalytic converter.
Hope helps (remember to rate this).
Bank on sensor is at top of exaust pipe on driver side
SOURCE: Need to know location of Bank 1 Sensor 1 on engine
If I am not mistaken bank one should be your driver side. However your sensor one will be before the cat converter. So you just have to find the o2 sensor before the cat converter on the driver side. Good Luck.
SOURCE: I need to know which O2 sensors are which: Bank 1
bank one upstream oxygen sensor on exhaust manifold bank two oxygen sensor after catalytic converter.tell me what code you are getting.bank 1 sensor 1 fuel system is too rich fuel pressure too high fuel pressure regulator leaking or more than 1 fuel injector leaking. fuel contaminated.check spark plugs if black carbon color fuel system too rich. if you getting code bank 1 sensor 2 check for air leaks in the exhaust system, air leaks intake manifold.look for vacuum lines leaks,look for vacuum leaks pcv valve and hose and make egr valve not stuck open or gasket leak.
1,837 views
Usually answered in minutes!
×