2000 dodge caravan wipers dont work. I ran hot wire to wiper motor, it works. I have power at wiper switch, but not sure which wires to check

Here are a few other things to check beside the fuse and relay:

Check Wiper Motor - the wiper motor is the driving force of the windshield wiper. Feel the motor and listen to a humming sound. If there is no humming, the motor is the problem. Check if the motor is working properly and see to it that its electrical connections are made properly. If you find that the motor is dead and beyond repair, get it replaced immediately.

Check For Break in Connecting Wires - the connecting wires of the motor sometimes go loose and that may cause the windshield wipers to stop working. Also check the battery plug connection which the motor has. Connecting the loose wires properly or fixing/replacing the plug might solve your problem.

Check Wiper Switch - another wiper assembly part that can malfunction is the wiper switch itself. Check for switch malfunction and if you find that is indeed the problem, get it replaced from a mechanic.

Check for Bent Wiper Arms - bent wiper arms can cause the operation of the wipers to be hampered. If the wiper arms are bent beyond repair, get them replaced immediately.

check fuse, check wire connection to wiper motor , check wiper motor.

The fuse could be blown, or the motor could be bad, or the switch may be bad, or the wiring in between.

CHECK FUSE IF FUSE GOOD.HOOK A JUMPER WIRE TO GROUND AND GROUND WIPER MOTOR.TURN WIPER SWITCH ON IF WIPERS WORKS YOU HAVE TO FIX GROUND CONNECTION. IF WIPER STILL DONT WORK.REMOVE THE COWL COVER.TURN WIPER SWITCH ON TO SEE IF POWER GOING TO WIPER MOTOR IF YES.REMOVE WIPER MOTOR HOTWIRE IT.IF WIPER MOTOR DONT WORK REPLACE IT.IF WIPER MOTOR DO WORK CHECK FOR BINDING OR DAMAGE LINKAGES.IF POWER NOT GOING TO WIPER MOTOR AND FUSE GOOD.WIPER SWITCH FAULTY OR IT HAS BROKEN WIRE FROM SWITCH TO WIPER MOTOR.

with the key on and the wiper switch in the low or high position tap the wiper motor with a screwdriver handle. If it starts working replace the wiper motor.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

COULD BE FUSE.IF FUSE GOOD.CHECK TO SEE IF POWER GOING TO WIPER MOTOR.IF YES.REMOVE WIPER MOTOR HOT WIRE IT USING JUMPER WIRES TO CAR BATTERY.IF WIPER DONT WORK IF HOT WIRED.WIPER MOTOR IS BAD.IF WIPER MOTOR WORKS HOT WIRED.YOUR WIPER LINKAGES BINDING. NEED LUBRICATING OR REPAIRED.

Look at fuses if OK look for broken wire around wiper motor, check to assure power is getting to the wiper motor then check the motor.

check wiper motor ground wire.make sure its tight not corroded.check wiper motor for binding or remove wiper motor hot wire to see if run with out stopping.if it run with out stopping its has a faulty switch or binding.spray pivots and linkages with WD40 to help lubricate them.if wiper motor dont continue running or stop while hot wiring it.replace wiper motor.

most likely the wiper motor is bad the second wire sould be a ground if you set meter to ohms you sould be able to get a low resistance to any good ground on the vehicle if the hot wire is hot any time key is on the bcm is controling the ground to operate moter and you should have a steady continuity on the ground side with switch on the fast postion an it will read on and off in the intermitant postion if both wires test good motor is bad when you replace motor let it cycle and shut it off before installing the arm on it

You did everything else. You have voltage going to motor,so I would say that was it.