Need to adjust low beam headlights on 2003 corolla

There will be no adjustment for low beam as the headlight assy. adjusts for both beams. Adjust lights on high beam from a distance of about 3 ft(1meter) The center of the beam to be slightly below center height of the light and slightly to the left (AUS) or right (USA). Face the car to a wall at night is best.

Your headlights need aiming correctly. There are screws next to the headlight the achieve this . Park the car on level ground about 2 meters (6feet) from a solid wall and turn the lights on to high beam. You will see the centre of the beam measure the height from the floor to the center of the headlight and mark this on the wall directly in front of the vehicle. The center of the beam has to be adjusted to to this point.Don't worry about low as the beam for low is set by the bulb and is correctly positioned in relation to high at all times

the headlights can be adjusted but you can't adjust the high & low beam separately, you can only adjust the light as a unit unless you have a separate high & low beam lights ( twin lights) ......hope this helps......cheers.

You shouldn't. The kit should come complete with everything you need. You might call them just to verify before forking out the "denaroes"

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

thats it my freind one on each side/Plaes rate my response thank you very much

its all the same the headlight is a complete unit you adjust both/ look for screws behind the headlight one each side one is for horizontal annd the other is for vertical Please rate my response thank you very much

when you switch your signal arm push forward for hi beam pull back low beam if you have regular beam and both beams are present then most likely it is your head light hand switch!! if fuse was blown you would have no head lights at all,so i would start with the swich good place to begin!

Go to mechanic !