The code is specific to the radio intalled into the vehicle. You'll have to remove the radio, get the serial number of the radio off the sticker on the rear of the unit, and call Jeep. Be prepared to provide proof of ownership. They will be able to get the code for you.
If you're lucky, you may be able to find documentation of the code in your owners manual. There is typically a card provided at the original sale date with the code printed or written down on it. Check the glove box for the manual and procedure to enter the code.
Good Luck!
SOURCE: 2004 grand cherokee jeep power windows and
Had to same problem with power grid on door to windows and locks. Turned out to be 3 broken wires just on the inside of door connection to firewall of engine. Took couple of hours to locate and fix by mechanic for $55.00 after I had already spent $89 at GMC dealer to be told needed new wiring harness for $1700 before labor! Will never go back to Dealer!
SOURCE: radio code for jeep grand cherokee 1997,
need to go to dealership so they canobtain code via srial number of radio
SOURCE: 2004 Jeep Grand Cherokee. Keeps stalling, engine
P0505 means the whole Idle Control system, not only the IAM. Check all related sensors (i.e. crankshaft sensor). Check with a voltmeter direct at the connector of the IAM if you get any signal. Remove the IAM from the TB, connect him, let someone switch your ignition key to ON. The IAM need to drive in/out for a short time to find the right position. Hold the IAM near a hard part, that they cant drive out completely! If IAM works fine, check the fuel pressure, check and clean your TB ( if not done yet). If that doesn't work, come back again please
554 views
Usually answered in minutes!
×