SOURCE: How do I replace a lowbeam headlight bulb on a 2008 GMC Acadia
You will have to go through your mud guards. Remove your tire, and look inside your wheel well, you will see two part mud guard, front half and back half. Just remove the 7 screws from the front half, 5 on the wheel well itself, and two on the bottom, retaining screw to the bumper, now depending on which side you're looking at anywhere from 5-7 plastic pop-its. Use a flat tip screw driver to loosen the pins up, then remove the pop-it studs. There are two on the bottom front that connect to the vehicle frame. Once this is removed, you can access your headlight assemby to replace both bulbs. Note, you will have to do this to replace your fog light bulb should it go out as well.
SOURCE: 2008 gmc acadia low beam light bulb changing
how do you change the low beam light bulb on the 2008 gmc acadia
SOURCE: How do you change the halogen bulb in the
under the hood there will be a large, plastic weather cover to unscew by hand, remove the 3 pin connecting plug, there will be a spring loaded clip holding in the globe, depress the looped end and divert it over to one side thsi will release the globe, assembly is in reverse, be careful as not to touch the end og the globe, as the oil on your fingers are detremental to its operation. No special tools required to do this. Good luck
SOURCE: how do you replace a low beam headlight on 2008
The front bumper cover has to come off to remove the headlight assembly! Yes, sounds very stupid, but it's the truth. The parking light on mine went out, hours later it was fixed. If you have the HID headlights you might have to replace the entire assembly.
940 views
Usually answered in minutes!
×