I don know how to fold my rear seat down in my 2002 chevy silverado 2500hd. I can make the bottom seat fold up but I want to bring the back of it down. Do I have to take out the seat all the way or is the some trick iam missing

Lift up on the rear seat cushion and fold it towards the front. Now pull the lever and fold the seat down,but make sure the bottom seat cushion is all the way down

First you reach for the tab near the center of each "half" of the back seat bottom at the back (in the crack of the seat). Pull the tab forward and up, pivoting the bottom of the seat toward the front. Ensure the front seats are forward enough to allow the seat bottom to lie flat on the floor. Next, reach up along the (outer) side of the seat back, and lift the lever, while folding the seat back forward. You may need to pivot or remove the headrest(s). The seat back should lie flush atop the upside down seat bottom. This works for my 2002 Olds Bravada, which is supposed to be similar. Good luck!

use the same pull strap you use to lift it.you may need to push the seat up a little while you pull the strap.mine sticks sometimes.

To fold down, follow these steps:
1. There is a loop located in the middle of the back seat - pull it forward and the bottom part of the rear seat will fold down
2. Wedge the the back seat, and it should not give you any trouble in folding down
3. To ensure that the seat goes all the way down- remove the headrest.
If your seat can not be folded-down, follow these steps to remove it:
1. Put some pressure on the bottom cushion of the back seat.
2. To release the bottom seat, pull the T handles, and then remove the cushion
3. There will be some bolts and screws on the bottom of the seat - remove them, and then you can pull out the seat.

Try to put pressure on the seat to release pressure from latch. Even sit on the seat and bounce while holding the lever to release

99% just pull out, the other s have a button on the seat right at the head rest.

The Signal Flasher is on the back side of the Fuse Panel. To access it, remove the driver side lower dash.

in the middle of the seat cushions in the back of the seat there is a little loop, pull that loop forward and that will have the seat's bottom pulled down to the floor agains the back of the front seats. Next simply apply a lil muscle to the back of the back seats and the seats should fold down nicely into the open space. Be sure to remove the headrests so the seat will fold all the way down. post any issues u may have.

the power steering lines are very short hoses approximately 8 inches long that go from the power steering pump down to the steering box, which is located on the frame, just below the pump. The brake lines run from the master cylinder(where you fill it with fluid on the drivers side firewall) down to the frame, and then follow the frame both directions; both to the front end and the rear end, along the drivers side frame rail, just on the inside of it. The fuel line runs along the same path to the rear.

there must be one hidden bolt left check that the seat belts aren't holding you back