How do I get the front end rotors off a 2001 Mitsibishi Montero Sport?

Mitsibishi Starter Diag And Install

If engine sits front to back, right side is bank 2. If it sits transverse, rear bank is #2.

As i remember it is qiut difficult .Either you have to remove front differential assy or rise up the whole engine.

Hi there:
Make: MITSUBISHI
Model: MONTERO SPORT
Year: 2001
Engine: V6 - 3.5L - FI - 6G74 - GAS


OE GAP .044"


On NGK - Standart Part Number BKR5ES-11
On Champion - Regular Part Number RC12MC-4


Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

jack up the car, first break lugs, and remove tire. There are two bolts on the front back side, if it like are endeavor then I compressed the caliper piston and then I had to take apart the caliper as the old pads did not come out, those are the two bolts on each end. then put back on. Once the caliper is off the rotor will come off as it is held on by the caliper. Just be careful with the caliper once it is removed as it is a brake line, you can use a hanger for it does not pull on the line when it is off the rotor. Good Luck Tim

email me and include whether or not it is 4WD or 2WD. [email protected]

its alot easier for you to get a service book then explain b/c you would never understand the steps which are to long to write here..

Same as any other car.

A socket wrench with a couple of sockets, a screwdriver, and a pair of pliers.

I'm at the exact same spot.... if anyone can throw us a bone on this I would greatly appreciate it!

your code is 1867