Need to replace the headlight assembly on front passenger side do i have to take off the bumper? for ponitac vibe 2003 also have dent on the area

It looks like there are just two screws in the top. Headlight assemblies are normally disconnected from inside.

Second image down

https://www.tascaparts.com/oem-parts/kia-headlamp-assembly-passenger-side-rh-92102a9650

no videos unfortunately

https://www.google.com/search?q=2019+Kia+Sedona+LX.+Headlight+assembly+replacement

..

you may need to remove front bumper

2008 328i Passenger headlight assembly removal.

The headlight assembly is held in by 4 "star" bolts (size 25); 2 visible on the top of the assembly, 2 not visible or easily accessible.

The 2 bolts not so visible require that the front half of the wheel well come off and the front bumper or "nose" of the car.... The bumper is what needs to come off, but there are 2 bumper bolts hidden by the wheel well.

The wheel well is held in by 7mm bolts, 2 of which are actually bolted to the bumper on the bottom.

The front bumper is held on with 7mm bolts on the bottom edge, and star bolts, size 25, accessible on the top edge. (Hood open). Here were my steps.

1. Jack up the car on the side you are replacing, remove wheel.
2. Using 7mm socket, remove all the bolts to peel off the front half of the wheel well. With the wheel well out, you can see the 2 other star bolts holding the headlight assembly, but you can only remove one of them... even if you were good enough to get both removed, the headlight assemble will not push out through the bumper.... Keep going with bumper removal.
3. Remove 2, 7mm bolts of the front bumper that are now visible up near the outer edge of the headlight assembly.
4. At this point I removed the bumper's top edge start bolts and bottom edge 7mm bolts about 3/4 of the way across the bumper...
5. The bumper is very flexible and you can now pull it back , reach in, and get that last difficult star bolt on the headlight assembly....
6. Don't forget the one electrical connector....
7. I also recommend testing the new assembly by plugging it in before removing anything

You need to remove the front bumper. Five push clips along the hood line, remove the headlight wipers (if equipped), one T25 screw in the front of each fender well, then two 12mm bolts under the headlights (1 each side). Then there are 4 10mm bolts holding the headlight in.

You will have to remove the front bumper to get to the bolts that hold the head light on
I would not recommend you try this unless you have some experience with this type of work

Its easy look at the bottom of the bumper has retainers and the fenders have a bolt on each side then just slide off

I have not done this yet but I have seen a DIY on hondacivicforums.com. From what i hear to remove the headlight assembly you have to remove the front bumper to get to screws that hold the headlight assembly on.

Hope it helps.

If you're talking about the cooling fan relay, it's behind the bumper cover under the passenger side headlight. Instead of taking the entire bumper cover off, you can take the right headlight assembly out, and cut a hole in the plastic cover. You won't see the hole after replacing the headlight, and I know several techs that do this. You might want to remove the battery, and look down to see where the relay is before cutting.

it says the dealer has to do it.
trust me its very difficult.

josh the only way to replace the headlight is to take off bumper now look at top should be roughly 4 retainers pull the top middle out and pull out do the bottom of bumper and the at fenders these are usually 10mm orscrew 10mm take them out and slide the bumper off buddy and then go backwards. if you need anymore info go to collisionrepairadvice.com