I have the bulbs -- but can not see how to change the bulb?
Depending on whether it is the front or the back turn indicator light will determine on what needs to be done. If it is the front turn indicator light open the hood of the car you may need to take the entire headlight out. The headlight may have screws, take the screws out then the front light will come out from the outside of the vehicle replace the burned out bulb. The bulb should snap right in and then put the headlight back in make sure you put all screws back in from the inside of the hood. Step2 If it is the back turn indicator light, go through the trunk of the vehicle. If there is a panel covering the lights you must unscrew the panel and then replace the burned out light bulb. Some panels can be folded down without removing all of the screws to access the lights. This light may not require for you to pop the entire light out you maybe able to just replace the bulb. After you have replaced it screw the panel back into place. The back light should not require the entire light to be lifted out just a simple bulb replacement. Step3 In replacing either the front or the back indicator light you must gain access to the turn signal housing which is usually in the same case as the headlight or your rear lights. It is very helpful to also get the owners manual out this will tell you exactly what type of bulbs you will need to get to replace the indicator bulb.
SOURCE: replace the front turn signal light bulb
you should have two tongues holding the main headlamp assembly, they are towards the inside of the engine compartement, slide them off upwards and wiggle the assembly and should come off, once off you'll have access to you signal light, hope it helps
SOURCE: Can't figure out how to change the bulb for turn signal on Jeep
it can be a pain because the screws are hidden. first you must remove the parking lamp raise the hood. one screw is visible from the top looking down at the lens...the other is hidden on the bottom side....look between the park laml and the turnsignal housing..a long phillip scew driver can reach it. once you have that removed lookng straight down at the turnsignal assembly you should see 2 screws. remove them and roll the assembly out and away from the body...you should see the bulb holder
SOURCE: rt front turn sighal burned out - how to access bulb to replace
There is a latch to the Van's outside just insert a flat blade screw driver and the turn light assembly will swing toward the middle of the van.
Once open the lamps twist out.
SOURCE: need replace turn signal bulb
YOU HAVE TO THE FRONT HEADLIGHT HOUSING TO REPLACE THE TURN SIGNAL BULB.
Testimonial: "thanks"
1,237 views
Usually answered in minutes!
×