Clutch problems what kind of clutch do i use for a 97 sunfire

The radio will have to be removed from the dashboard.

Then post the radio make+model plus all the letters+numbers on any labels,barcodes or engraved in the metal casing.

I don't believe you will be able to use that motor, the only one that will work would be one from another 1999 or a 2000.

As long as the 96 one looks the same as the 97 and fits properly.

Its either the clutch fluid is wrong or not at the correct levels or it has not been bled correctly.

INSIDE THE TRANSMISSION...HAVE TO REMOVE THE SIDE PAN OF THE TRANS.

try checking the coolant resivoir level sensor has not come loose or got a bad conections in the plug.

Most likely the shifter is defective.

your problem is in the slave clydliner.. this will cause the clutch to leak dot3.. look under the car at the tranny, there is long rod sticking out of tranny, thats where the slave pushes to release the clutch.. follow the lines up to the clutch master cycdiner, making sure there are not leak in the line.. if it is the slave, once you replace it you will need to bleed the slave.. same as you would your brake..have some one pump the clutch pedal down three or four times hold and let you release the bleeder valve on the slave.. repeat this till the clutch feels back to normal.. sounds alot harder than it is.. good luck keith.. if any more questions contact me at [email protected]

gear linkage is out

please read my solution