When i turn the lights on and pull the switch for the fog lights nothing happens whats wrong?

If it is a late model car using a CANbus system you need to be aware the switches do not actually control the current to the lights but merely inform a computer the lights should be switched on and a local computer places a request for this on to the information highway where another computer will receive the message and comply or if there is a fault, nothing happens or strange things happen.

The lamps can be checked in the traditional manner and so can the switches and even some fuses but after that it will require specialised diagnostic equipment to locate the fault.

Hi, if you finf your car fuse bos only way is to test them one one. If you find one not bring light tester on pull out and check it. On th fog light is plug connection check if is power on that wires. if not something wrong with your switch doesn't open circuit to the plug wire for the fog light.

Are you sure it has fog lights? If yes has the switch been replaced with the wrong switch? If the switch will not pull out to turn on the fog lights the first thing that comes to mind is a bad switch. I would probably start with that.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

may be a relay or fuse or a faulty switch

With the switch in sidelight or dip

position, pull the switch to its first

position to turn on the front fog lights.

Pushing the switch in or turning it to OFF
or AUTO will turn off the front fog lights (this is for the front)

With the switch in any position except

OFF or AUTO, pull the switch to its

second position to turn on the rear fog

lights. This will also turn on the front fog

lights unless main beam is selected.

Pushing the switch in or turning it to OFF
or AUTO will turn off the rear fog lights (this is for the rear)

Exterior lighting

Exterior lighting switch

A. OFF.

B. Side (parking) lights.

C. Headlights.

D. Auto.

E. Front fog lights.
F. Rear fog lights.

It is the round knob nest to the steering colume

i believe the one that has the light is ur fog lights might be ur baulbs r burnt out the other sgs is second gear start for winter conditions

to turn on the fog lights, its the same switch that you use to turn on your head lights. Turn the dial to the right to turn on your head lights and then pull it towards you. thats how you turn your fog lights on

Or you could just pull out the relay under the hood, it's marked fog lights, pull the relay out. If your hi beam indicator is flashing with your fog lights on them selves. Could be the multi function switch. That controls turn signals, headlights, fog, I have seen many of those go bad.

FROM: Lusty Kid:

Your fog lights should not work with high beam... they should work with the low beams. they are connected wrong, which probably drew too much current through the light switch burning out the contact points for the parking lights in the switch

Start by Fixing the fog light connections to work with low beams. Appears to me this was not factory installed. Aftermarket kit maybe! Then see if your parking lights work. If parking lights don't work still and everything else works, replace the light switch $50 at the dealer. The switch works the fog lamps when you pull out the knob to turn on the fog lamps when the lights are turned on. When the fogs are on you will see a little amber light to let you know your fogs are on. When you switch to high beam the fog lamps go off. Again if its not working that way, then is wired wrong. Needless to say, there should be connectors in the harness of the lights for the fog lamps. Use those if possible with the kit that you can get at the dealer, or you can splice the connector with those blue splicing clips sold at the auto part store. Make sure ground is ground when splicing and water proof the connection sith silicone and tape.

i would go with the nissan stuff.