Do you have detailed instuctions or a visual guide on removing the motor from a 2003 tiburon with a 4 cyl. and a standard transmissin?
Http://www.analogstereo.com/pdf/om/hyundai_tiburon_owners_manual_2003.pdf
•
Mark all wiring and hoses to avoid misconnection.
•
Inspection the timing belt before removing the cylinder head.
•
Turn the crankshaft pulley so that the No. 1 piston is at top dead center
1.
Disconnect the neagative terminal from the battery
2.
Remove the engine cover.
.
Drain the engine coolant.
Remove the radiator cap to speed draining.
4.
Remove the intake air hose and air cleaner assembly.
(1)
Disconnect the AFS connector.
(2)
Disconnect the breather hose from air cleaner hose.
(3)
Remove the intake air hose and air cleaner.
5.
Remove the upper radiator hose (A) and lower radiator hose (B).
6.
Remove the heater hoses
7.
Remove the engine wire harness connectors and wire harness clamps from the cylinder head and the intake manifold.
(1)
OCV(Oil Control Valve) connector (A).
(2)
Oil temperature sensor connector (B).
(3)
ECT (Engine Coolant Temperature) sensor (C) connector.
(4)
Ignition coil connector (D).
(5)
TPS (Throttle Position Sensor) connector (A).
(6)
ISA (Idle Speed Actuator) connector (B).
(7)
CMP (Camshaft Position Sensor) connector (A).
(8)
Four fuel injector connectors (B).
(9)
Knock sensor connector (C).
(10)
Disconnect ground cable (D) from the intake manifold.
(11)
Front heated oxygen sensor (A) connector
(12)
PCSV (Purge Control Solenoid Valve) (A) connector.
8.
Remove the fuel inlet from delivery pipe (A).
9.
Remove the PCSV hose (A).
10.
Remove the brake booster vacuum hose (A).
11.
Remove the accelerator cable by loosening the locknut, then slip the cable end out of the throttle linkage.
12.
Remove the power steering pump.
13.
Disconnect the inhibitor switch and solenoid valve connector (A).
14.
Remove the transaxle range switch connector (A).
15.
Remove the vehicle speed sensor connector (A).
16.
Remove the control cable transaxle range switch nut (A).
17.
Remove the clip (A) of the control cable.
18.
Remove the input shaft speed sensor connector (A).
19.
Remove the output shaft speed sensor connector (A).
20.
Remove the transaxle earth cable (A).
21.
Remove the start motor cable mounting bolt (A).
22.
Remove the starting motor connector.
23.
Remove the alternator connector.
24.
Install the SST(09200-38001), the engine support fixture and the adapter, on the engine and transaxle assembly.
25.
Remove the engine mounting bracket (A).
26.
Remove the transaxle mounting bracket (A).
27.
Remove the front tires.
28.
Remove the ABS wheel speed sensor (A).
29.
Remove the caliper and hang the caliper assembly (A).
30.
Remove the knuckle mounting bolts
31.
Remove the power steering return hose (A) and drain the power steering oil.
32.
Disconnect the rear oxygen sensor connector
33.
Remove the front muffler
34..
Remove the steering u-joint mounting bolt
35.
Remove the sub frame bolts
36.
Remove the engine support fixture and the adapter.
37.
Jack up the vehicle
×
945 views
Usually answered in minutes!
colors of wire conecting to sensor
×