Chech light on. Sunroof window does not open. What to do?

Here's a description the sun roof
Power Sunroof System Components
The power sunroof system consists of the following components:
• Sunroof module
• Sunroof switch
• Sunroof motor, with 2 hall effect sensors and limit switch
• Sunroof window
• Sunroof sunshade panel
• Power supply for the sunroof module: RAP 25 A
• Ground G402

Override
The override function is used when needing to force a closing of the sunroof window. To override the system:
Turn ignition to ON.
Rotate the sunroof switch to the close position.
Press upward.
The sunroof switch data 6 circuit, or override circuit, will become grounded at the sunroof module. As long as the sunroof module sees this input, it will continue to slide the sunroof window to close, regardless of the other sunroof switch data circuits inputs.

Important: This sunroof system is timed from the factory in order to allow the actuator to shut off automatically when the sunroof window reaches a certain position. Use extreme care when removing the actuator from the sunroof module. This may cause the timing to be thrown off. This may damage to the sunroof. Anytime the actuator needs to be removed from the module, ensure that the sunroof window is in the fully closed position.
Remove the sunroof window. Refer to Sunroof Glass Panel Replacement .
Slide the sunshade fully rearward. Move the sunroof window to the vent position. Remove the sunroof screws (two on each side). Remove the sunroof window from the module.
Place the sunroof module in the fully closed position. Remove the headliner. Refer to Headlining Trim Panel Replacement in Interior trim.
Tools Required ?€¢
J 38778 Door Trim Pad and Garnish Clip Remover

?€¢
J 2772-C Headliner Installer

1. Remove the sunshades. Refer to Sunshade Replacement .
2. Remove the overhead console, if equipped. Refer to Roof Console Replacement .
3. Remove the sunshade retainers. Refer to Sunshade Anchor Replacement .
4. Remove the power sunroof switch, if equipped. Refer to Sunroof Switch Replacement in Roof.
5. Remove the sunroof trim lace, if equipped. Refer to Sunroof Seal/Molding Replacement in Roof.
6. Remove the dome light, if equipped.
7. Remove the coat hooks. Refer to Coat Hook Replacement .
8. Remove the assist handles. Assist Strap Replacement
9. Remove the rail lamp. Refer to Roof Side Rail Lamp Replacement in Lighting.
10. Remove the windshield side garnish molding. Refer to Windshield Pillar Garnish Molding Replacement .
11. Remove the upper quarter trim panels. Refer to Rear Quarter Upper Trim Panel Replacement .
12. Remove the center pillar upper trim panel. Refer to Center Pillar Upper Trim Panel Replacement .
13. Pull down on the door opening weatherstrip seal on both the front and the rear doors.
14. Remove the 2 rear retainers (2) using J 38778 Door Trim Pad and Garnish Clip Remover. Disconnect the headliner electric harness at the right side of the rear window shelf. Rotate the right front seatback to a horizontal position. Remove the headliner from the vehicle through the right front door.
    

Disconnect the electrical connector from the actuator.
Important: Before removing the actuator, ensure that the pins J 41718 are tight and holding the cable.
Thread the J 41718 into the front sunroof window screw hole in order to retain the cable adjustment. Remove the sunroof actuator screws. Remove the sunroof actuator from the module. Did you look for a video on youtube ?

If the sunroof is anything like the power windows, the auto function has to be reprogrammed by holding down a bout 5 seconds, up about 5 seconds, down about 5 seconds and up about 5 seconds. I know there is probably a faster way, but since that way works, I wouldn't want to hand out any other kind of advice.

Some sunroofs have a open switch like the drivers window. You push it and the window will open automaticly. The button on your sunroof could be jammed so even though you can close it as soon as you release it, it will auto open on it's own.

I would say something with the remote system.can you unlock the doors and roll windows down with the remote?

For sunroof related problem,if your exact car model is provided,then it will be better.But in this case,i suggest you to check the link below:----How to Remove Power Sunroof on Acura Integra? http://repairhelpcenter.blogspot.com/2011/11/how-to-remove-power-sunroof-on-acura.html
------------How to manually close Sunroof on 2000 Lincoln Navigator? http://technoanswers.blogspot.com/2012/01/how-to-manually-close-sunroof-on-2000.html
-----------No power to Courtesy Lights and sunroof? http://technoanswers.blogspot.com/2012/01/no-power-to-courtesy-lights-and-sunroof.html
-----------This will help.Thanks.

to reset any window open it half way down then
let it fully close and hold the button up for about 10 seconds. do this mithod to all auto windows encloding the sunroof . afterall try them from the driver side

put key in drivers door and hold over (unlock) for 30 secs, windows go down, then open sunroof fully.then put key in drivers door and hold over(lock) for 30 secs windows will go up and sunroof will close,you have just reset the system.....if sunroof rollsback again then the park switch is faulty.

Some customers may comment that the sunroof will no longer respond to the control switch while in a vented, partially opened, or fully opened position.
Cause A software issue with the sunroof control module may cause the sunroof control module to incorrectly indicate a "closed" position, which may result in no power to the sunroof motor.
Correction Verify the customer concern. If a condition is present, replace the sunroof control module with a new sunroof control module, P/N 15847643. Refer to the Service Procedure in this bulletin.
Service Procedure

1. Verify the customer concern by opening and closing the sunroof. • If the sunroof will not open , check the power windows. - If the power windows are also inoperative, check the fuse. If the fuse has opened, refer to Corporate Bulletin Number 05-08-64-004 to install 30A circuit breaker. - If the power windows are fully functional, refer to "Power Sunroof Inoperative" diagnostics (SI Document ID# 1392967) in the Body section of the 2005 Chevrolet Equinox or Saturn VUE Service Manual. • If the sunroof will open (or is already open), but will not close , proceed to Step 2.
2. Replace the sunroof control module. Refer to "Sunroof Control Module Replacement" procedure in the Body section of the 2005 Chevrolet Equinox Service Manual (SI Document ID# 1196049) or Saturn VUE Service Manual (SI Document ID# 1710479).
3. Open and close the sunroof in order to confirm that the customer concern has been resolved.

Parts Information Part Number
Description
Qty
15847643
Sunroof Control Module
1

Make sure nobody plays with the car key after you lock it because if anybody push the unlocking button on your key remote it will unlock the car and if they push and hold it long enough it will open the windows and sunroof