Question about 2007 Suzuki Forenza Sedan

1 Answer

1985 Kaw. Eliminator The bike will run fine in chike mode but will not idle it will cut off. Do i need to adjust the choke linkage or reset the idel control?

Posted by on

  • gregoryd_hea Oct 06, 2010

    great answer this should work



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Expert
  • 2,973 Answers

The idle control, ie, the air and fuel jets have to readjusted so that the idling speed increases a little and then the bike will not stall/cut.

Posted on Oct 06, 2010

  • Rinoo Kumari Oct 06, 2010

    If you adjust the choke then you will burn more fuel. While if you adjust the idling jets on the carb then it would be correct air and petrol mixture that will go into the cylinder.



1 Suggested Answer

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Carburetor problem?

check the setting for the auto choke and adjust the linkage with it.. Adjusting screw on the throttle butterfly that runs on the fast idle cam of the auto choke.

Feb 18, 2014 | 1985 Nissan Pickup

1 Answer

1985 monte carlo ss

choke needs adjusting and/or a vacuum actuator not short must be the choke valve not opening fully...should be fully open of course when engine is at operating temperature..some linkages could need bending to adjust them also...

Dec 18, 2013 | Cars & Trucks

1 Answer

Sputters and dies on cold start, significant drop in gas mileage.

You need to rebuild the carburetor or clean the choke linkage and make sure the choke valve closes cold.

Nov 12, 2013 | 1985 Isuzu Pickup

1 Answer

Twin hs2 su carb linkage diagram

YOU dont need a diagram for twin carbys as put them on the manifold back off all throttle linkage and adjustment screws make sure thay are all down, and turn both screws down till they touch, now back off the jets nuts under the carbys and then undo them 2 turns only[thats the ones the choke move up and down] now HB on out of gear a little choke start engine adjust 2 screws 1 more turn each and choke in
make sure you have very thin oil in pistons, then when running adjust jets 1flat at a time when it runs smooth lock up the linkage and adjust screws till idle at 600 RPM.

Aug 15, 2012 | Austin-Healey SPRITE Cars & Trucks

1 Answer

1985 c10 choke stuck open it's cold and damp

Absolutely not, the automatic choke is defective. Replace that and it should be fine. It will need to be adjusted when cold to fully closed position. Check vacuum lines as vacum pulls the choke back when engine is started.

Nov 18, 2017 | 1983 Chevrolet Silverado

1 Answer

Engine idels at 3000 rpm after replacing carb and vacuume lines with new parts.

There should be an idle speed adjustment screw near where the throttle linkage connects to the carburetor. Turn it CCW a number of turns until the speed drops down. Make sure the choke has completely released before making this adjustment. Hope this helps!

Sep 23, 2010 | 1985 Nissan Pickup

1 Answer

Choke Light rough idle

adjust your carb, the 2 screws on each side of the carb adjust so you can get the car to idle correctly, also check your distributor

May 26, 2009 | 1985 Chevrolet Chevy

1 Answer


Sounds like a engine warming up and the choke opening without being allow thh reset the linkage. When it does that, tap the throttle and see if it drops to proper idle. choke may need adjustment for standing warm up. good luck

May 17, 2009 | 1984 Toyota Land Cruiser

Not finding what you are looking for?
2007 Suzuki Forenza Sedan Logo

Related Topics:

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts


Level 3 Expert

85020 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides