My 93 cadillac seville blower motor was staying on .so i disconnected the conector to the motor under the hood. i found that there was battery voltage on connector. then i jumpered the battery to terminal on the blower motor. the blower motor started turning without other terminal being grounded or connected to anything. could this indicate a short in the blower motor somewhere. if i operate the switches inside the car i didn,t get a voltage change of any sort on the blower motor connector. do most blower motors than work off of a current change? i had this problem many years ago and it wouldn,t show any changes to control the motor, voltage wise and we had considered wiring changes, a new switch ,(god bless the old days of a simple make or break contact), or blower motor we finally chose blower and it worked. thaats why i asked about the current control cause in those days they didn,t have such an idea. maybe things are still the same

If I am not mistaken, it is under the rear seat bottom cushion.

4504204 A/c blows fuses - Document Download

thebestsolutions.top/F/cars/t4504204-c_blows_fuses

4504204 a/c blows fuses ive had feron checked replaced a/c relay fuse last about 10 ... I have a 2006 impala that is blowing the 10 amp fuse to the ac/compressor/a new will last ... 93 corolla 1.8 No start Blown ignition fuse ... i have a cadillac deville the a c blows hot air on ... air con fuses air con heating mk3 mondeo talkford.

Blower Motor Problems ' Auto Repair Help - YouTube

? 4:22
https://www.youtube.com/watch?v=2vmfxYg8LoY
Sep 27, 2009 - Uploaded by mgittelman
I have a 1996 Cadillac DeVille that the blower motor stays on unless you unplug it. ... +mgittelman hi mate ...

Cadillac Repair - Questions and Answers from October 12 ...

en.allexperts.com > Shopping > Vintage Cars

Nov 3, 2006 - 91 Fleetwood "check engine" light, 10/31/2006, Tom Joy ... Q: My 95 Deville blows air when the heat is on, but the air never warms. ... 96 Deville Interrior Lights Inoperative & 3.2 Amp Draw on Body Fuse 3. ... Q: I have the 93 cadillac deville and those codes came up right after a transmission replace.

Cadillac Seville Questions - Heating/AC fan runs when car ...

Maybe check again, the only other fuse box is located in the trunk on back wall. Have to drop trunk liner.

INFORMATION
Subject:
Revised HVAC Blower Motor Installation Procedures

Models:
1994-1997 Cadillac Seville
1994-1999 Cadillac DeVille
1994-2002 Cadillac Eldorado

The intent of this bulletin is to provide technicians information regarding the proper installation of the Heating, Ventilation and Air Conditioning (HVAC) Module blower motor (with impeller) assembly.



The current available HVAC Module blower motor for the above listed vehicles can be identified by the three mounting holes (1). The original equipment blower motor had five mounting holes.

In order to avoid confusion and ensure a high level of customer satisfaction, when replacing an HVAC Module blower motor, refer to this bulletin for the appropriate procedure.

Eldorado/Seville-HVAC Blower Motor
Caution: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.

Removal Procedure
1. Disconnect the negative battery cable.

2. Remove the camshaft cover.

3. Remove the blower motor.

^ Disconnect connector from the blower motor.

^ Remove the blower motor screws (either 3 or 5 screws).

^ Remove the blower motor from the HVAC Module.

Installation Procedure
1. If present, remove the 2 ribs located on the barrier. Refer to Step 3 and the illustrations in the Instruction Sheet, P/N 52494110, found in the blower motor kit.

Important: Ensure the blower motor gasket makes a complete seal around the blower motor.

2. Install the new blower motor with heat shield. Refer to Steps 4 and 5 in the Instruction Sheet, P/N 52494110, found in the blower motor kit.

3. Install the blower motor retaining screws.

Tighten

Tighten the screws to 4 N.m (35 lb in).
4. Tighten the lower heat shield retaining screws to 4 N.m (35 lb in).

5. Connect the connector to the blower motor.

6. Install the camshaft cover.

7. Connect the negative battery cable.

It is under the hood, look at the center of the firewall, behind the engine. See the round metal object protruding out from the duct? That is the blower motor.
Disconnect the electrical harness, the cooling hose and the retaining
screws then remove the unit

a bad blower control module under the hood.

Yes you can test it that way.

you will need to lower the rear of the engine cradle to help gain access. this is not a job for a guy in his yard, a shop will need to do this for you.

REPLACE THE BLOWER CONTROL MODULE. IT IS LOCATED IN THE ENGINE COMPARTMENT AT BACK CLOSE TO WINSHIELD. IT HAS 2 CONNECTORS AND IS UNDER FUSES AND RELAYS PANEL NEAR FIREWALL. IT STICKS DOWN IN BLOWER CASE AND HAS 7MM SCREWS HOLDING IT IN PLACE. GOOD LUCK!

At (probably behind) the switch.