Correction: flasher may be located elsewhere other than the fuse box, I read.
Older models of the Lincoln Town car had the flasher in the fuse box.
is there a relay switch for the turn signals, they will not work in cold weather? the fuse box does not label actually where the fuses or what is there.....
×
SOURCE: turn signals and emergency flashers won't work
you need to replace the flasher relay... it's often located in the fuse panel under the dash.... it's generally larger then the other relays.... and it may possibly be blue.
SOURCE: 1997 sonoma turn signal flasher
it is inside, under dash, on left side is a plastic sound protector, mine had 3 screws holding it up, drop this down and straight in you will see a 1" round thing - this is the flasher, pull it out and replace with new one (there are two flat prongs that plug in). It appears this is a well guarded secret!
SOURCE: 1997 sonoma turn signal flasher
The flashers are located behind the instrument panel trim, roughly between the base of the steering wheel and the ashtray, just to the left of the car lighter. To access the flashers, you need to at least loosen the lower instrument panel trim. Just under the steering column there are two screws with star heads. One to the left of the column and one to the right. You need to remove both of these screws. You will need to remove your ashtray. On the upper left corner of the hole left by removing the ashtray is a 9/32 hex head screw. You need to remove it. Once these three screws are removed you should be able to pull down on this portion of trim under your instrument cluster. When you do this it may cause trim around your instrument cluster to loosen that you can just pop back into place with your hand. You won't need to pull down to far on this trim piece as there are still some screws holding the bottom. You should be able to pull it down far enough to see the flasher units behind and just to the left of the cigarette lighter. There are two flasher units and I found that the one on the right is for the turn signals.On the left the other is for the hazard flashers. It may be a hand scraping experience to replace the flasher but it beats paying someone to do it for you. They are easy to recognize because the are silver and round metallic plug ins. The flasher unit on the left is for the emergency flashers and the one on the right is for turn signals. You can place the emergency flasher unit into the slot the turn signal unit belongs until you get a replacement. These flasher units are pretty cheap.
SOURCE: No turn signals or emergency blinkers
I had the same problem twice before. Solved it the same way both times. In my case it was the Hazard switch at the top of the steering column. It was stuck. I knew it was that because the signal lights had been functioning perfectly until I parked my car alongside the road with the hazard lights on to do some nighttime fishing and sip a little white lightnin'. (just kiddin' about the white lightnin')
When I got back in my car to go, I turned off the hazard lights but I had no turn signal lights! So I kept pushing that hazard button up and down for about 30 times with my left turn signal arm down until it started working again. So after having this happen to me twice, I learned a valuable lesson: Don't ever use hazard signals in this car.
Hi,
If I understand you right based on your post/description, the signal lights would still turn on even if any or both of the flasher relays are removed. Should this be the case, then the signal lights are not getting the power from the flasher relays but from the brake light circuit.
Perhaps your concern is not with any of the flasher, but simply missing or loose ground more particularly with the rear lights. Perhaps you could try determining which of the wires for the brake lights and signal lights (as they come out of the light assembly) would be ground . A test and even possibly a temporary workaround is to hard wire a second ground connection from the determined ground wire of the lights and attach it to any conveniently located bolt or screw to the body. it may be to your advantage to do this on all the rear lights assembly.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards. Thank you for using FixYa.
1,409 views
Usually answered in minutes!
×