Open the trunk and on the inside of yout trunk lid you will see a gray plastic socket for each light.
push in and turn the socket counter clockwise. when you feel it come loose remove it from trunk lid.
if the black rubber ring does not come off with the socket pull it off and put it on the socket so you can see where to line up the holes when you re insert the socket.
pull out the old light bulb and insert the new one.
line up the notches on the socket with the holes on the trunk lid and re insert the socket.
push in and turn clockwise to lock into place.
note: be sure to wear gloves when doing this. there are screws coming through the inside of the trunk that hold the light cover onto the outside of the trunk. the points of these screws are on both sides of the socket that holds the light bulb. since these are older cars it is likely that these screws are rusty. wearing gloves will keep you from cutting your hand on a rusty screw if you happen to slip when trying to turn the socket.
1,465 views
Usually answered in minutes!
×