Hi.
Here the belt routing for 2005 Dodge Sprinter 2005, whch was sold only with the 2.7 engine mounted:
Fig. Accessory Belt Routing-A/C Compressor (1), Power Steering Pump (2), Tensioner (3), Crankshaft Pulley (4), Water Pump (5), Alternator (6), Idler Pulley (7)-All Engines
Here a different view:
Fig. Fan belt routing-Fan pulley (1), Fan belt (2), Crankshaft pulley (3)-3.0L engine shown
PROCEDURE Removal & Installation
2.7L Engine
1. Loosen the tension adjust and remove the A/C compressor drive belt.
2. Attach a 3 / 8 inch drive ratchet to the automatic belt tensioner.
3. Rotate the belt tensioner counterclockwise to release the belt tension.
4. Remove the accessory drive belt, starting with the water pump pulley.
To install:
1. Position the accessory drive belt around every pulley except the water pump pulley.
2. Rotate the drive belt tensioner clockwise, install the accessory drive belt and release the tensioner.
3. Position the A/C Compressor drive belt over the crankshaft pulley and A/C compressor pulley.
4. Tighten the drive belt tensioner.
5. Ensure the belt is seated properly on all of the pulleys.
If this solution was helpful, then please do not forget to Accept.
Writing dedicate solution, sharing skills, researching and extracting info from service documents takes time, and your feedback is important for us.
If you repute any solution useful, please click on Accept.
All the best.
Ginko.
Hi Vasils, please let me know how it goes.
Thanks.
Ginko.
I have also to add a note. The fan belt routing published is only for 3.0L engine. The serpentine belt routing (drive belt) is the one in first two diagrams.
Please let me know how the job goes. Let me know in case you get problems accepting the solution.
Hi.
Did you receive my comment?
×
Hi,
Look at the below diagram :-
Let me know,if needed further assistance.
Hope i helped you.
Thanks for using ' Fixya ' and have a nice day!!
9,567 views
Usually answered in minutes!
It is not dodge sprinter diagramm
I have 2.7L engine
×