Front door adjar light on dash and overhead map lights is staying on on my 2003 Mazda tribute.

Search Results

Failure of EGR Differential Pressure Sensor : Mazda Tribute ...

repairpal.com > Problems > Mazda > Tribute
Check Engine Light and Hesitation or Stumbling While Driving on Mazda Tribute ...this is my second egr valve and car is not picking up the right sped and when ... Mazda Tribute 2003, replacing burnt DPFE, connector bunrt, Need color pinout. ... Drivetrain · Electrical & Lights · Engine · Exhaust & Emissions · Heating & AC ...

Check Engine Light Diagnosis Cost for Mazda Tribute ...

repairpal.com > Estimator > Mazda > Tribute
A Check Engine Light is turned on when the Mazda Tribute engine control module detects a fault in the emissions system. One or more diagnostic codes will be

Usually the oil warning light means the engine oil pressure is low, or the sending unit has failed.

Page 116 and 117 of the manual explain that there's a two-position slide switch on the map light, DOOR and OFF. The back light has three positions, ON, Door Activated, and OFF.

Pages 116 and 117:
http://techinfo.honda.com/rjanisis/pubs/om/ACC080/ACC0808OM.pdf

I'm fairly sure the overhead light has a switch where you can turn the door circuit off. You might want to check on that.
If the symbol on the dash does not come on when the door is opened, the problem could be the sensor in the door.

There is a sensor in the door handle that sensor will need to be replaced

Everything you said has stopped working is controlled by the body control module or as Mazda/ Ford calls it a general electronic module(GEM). If the fuses are good may need to hook up to a scan tool to see if the GEM is working and controlling outputs to these problems.

we just replaced the alternator in our 2003 mazda tribute then we were driving it at night and the headlights,dash lights were flickering as if ready to go out.....need help what to do

the door adjar switch is the problem. the cargo light stays on until 35mph, as well as the overhead dome light. i just took the bulb out of the dome light and dont worry about the cargo light. it stays on for 30 min after the truck is turned off if the switch didnt trip properly. it shouldnt cause any problems as long as your batteries are good. i havent replaced the switch yet but it should be on the part of the door by the latch. get the replacement part and do a visual I.D. when you get the panel off. then replace it. the sensor is only 14$

Spray some WD40 into the latches on the side of the doors then open and close the doors several times firmly.This will unstick the door adjar switch most of the time.Start with drivers door first.

The door switch is stuck on or the wire is shorted to ground.