SOURCE: Jeep wrangler Fuse box
i had the same problem. i drive a 95 so im not sure if it differs from were the fuse box is. look righ above you pedals to your far left. it should be right there. also if you instruments went out it will be a 15 fuse. its a blue fuse. next my panel went out cuz of the wires on my transmission. if yor looking at your jeep at the front. the wires will be on your left. make sure they are not burned or anything. it will be right on the side of your tranny. mind got burned by the exaust so they were shorting. check that is and see if that is what is it. for a temp fix just put some electrical tap around the wires and you should be set for a wile. good luck
SOURCE: 1995 jeep wrangler dashboard lights don't work. it's not the fuse
are all dash lights out???
SOURCE: 1991 jeep wrangler clutch
U have what is called a hydraulic clutch, one of the hydraulic cylinders hs failed, there is a master and a slave cylinder. The most likely and most common cylinder to fail is the slave cylinder, this requires the transmission to be pulled out to replace it. the art is around $125.00, while the trans is out u might as well replace the clutch, the labor is about the same. Here is a picture of the part, let me know if u can see it.
SOURCE: Removing doors from Jeep Wrangler - Dome Light Stays On
I have a 97, and my fuse for that is behind the glovebox. Open the box, slide the end of the strap to disconnect it, then remove the box. The fuse is marked. Something like "Dome lt. elim." I think it's located one up from the bottom right. This can actually be done without removing the glove box. For a more permanent fix, quadratec.com has a switch that plugs into the fuse location and mounts under the dash, so you can just flip the switch. Hope this helps.
SOURCE: my 1990 jeep cherokee dash lights fuse blows
it might not be that. check your headlamp relay. i know sounds weird but just do it. when i bought mine it had already been replaced with the wrong one so it kept blowing it and the radio. replaced with stock part and just like that no more problems. hope it helps
207 views
Usually answered in minutes!
×