Removal & Installation - 4.6L, 5.4L & 6.8L Engines
Fig. Remove the retaining bolt for the CKP sensor and remove the sensor from the front cover (click for zoom)
To install:
Hope helps (remember to rate and comment this).
SOURCE: crankshaft sensor located 98 jeep grnd cher 4wd 6cy
it is located at the back of the engine on top of the transmission bell housing,the plug runs over to the passenger side of the engine bay and it comes out from behind the engine,you can actually get your hand on the sensor itself from under the hood on the drivers side,and i believe its a 13mm bolt holding it in,the new sensor will have a sticker on the end of it...leave it there,it is used for correct spacing between the sensor and the flywheel,hope this helps
Testimonial: "Everything was just like you said but as a not atleast for my jeep it is an 11mm not 13mm. Works great so far (keep fingers crossed) "
SOURCE: 98 Ford Escort zx2 2.0L 4 cyl 5 speed transmission PVC Valve
LOOK ON INTAKE AROUND AIR FILTER HOUSING AND VALVE COVER.
147 views
Usually answered in minutes!
Is there a diagram of this sensor? Thanks
×