SOURCE: 1988 Jaguar xj6 No forward in the automatic trans rev works fine
the linkage is just a slight bit off, it parks between gears when you shift into the slots. Disassemble the shifter from the center console, and slowly move just the cable its self between the positions and see if you have forword gears. When you find and sync the gears, then tighten the cable to the shifter so the positions match the notches in the shifter.
SOURCE: 1996 Jaguar xj6
my 1995 xj6 jaguar windshield wiper don't work, cannot locate the fuse for the wiper, as i do not have the owner manual to see which is the fuse for the wiper in the fuse box
SOURCE: 1988 jaguar xj6 engine turns
Hi
Sounds like fuel.
Check fuel inertia cut off switch is pushed down for on.?
Check for fuel pressure to the engine.
Sure your fuel is not water contaminated ?
Possibly the flow meter is faulty, or has an air leaks on the hose going to the inlet manifold.
I see you posted this on the 14th Dec O8 so perhaps you have it running OK by now ?
Good Luck !
John.
SOURCE: i have a 1988 jaguar xj6 and the outside door
If you havent' already broken the door handles tugging on them, inside the door you will find a linkage with a tensioner adjustment. You need to tighten that linkage adjuster. You will find if you take off the inside door panel and pull the linkage manually the door retanier will actuate. The job is a PIA, and requires a couple of very long, very small box wrenches. Dont attempt to adjust the linkage without loosening the retaining nut, the linkage will shear right off, thus making the outer door handles permanently locked Good luck.
949 views
Usually answered in minutes!
×