1997 Dodge Dakota Logo

Related Topics:

Posted on Nov 05, 2017

1997 Dodge Dakota park and signal fuse blown

The park and signal fuse blows when i start my 1997 Dodge Dakota. With vehicle off and the ignition switch forward the lights work, rotatiing the key to start blows the park and signal fuse. trailer package has been removed and returned to factory, all bulb sockets checked - any help for trouble shooting would be appreciated

5 Related Answers

motor1258

Mike Butler

  • 6674 Answers
  • Posted on Nov 29, 2008

SOURCE: LEFT TRAILER TURN SIGNAL DOES NOT WORK

I'd get a 12vdc test light if you don't have one already & start from plug, and keep probing back from there. It may be as simple as a bad connection under truck where joined into harness.

Ad

Anonymous

  • 50 Answers
  • Posted on Apr 12, 2009

SOURCE: need wire diagram to hook up trailer lights, truck not factory equipped w/harness,

I'm assuming you're just going to splice into the tail light wiring so that's what these wire colors are:
at the tail lamp 3 way connector:
black and yellow = park lamp
dark green and brown = left turn signal
there should be another connector with violet and black wire for reverse lights.
the stop lights are turned on through the turn signal circuits.

Anonymous

  • 1305 Answers
  • Posted on May 28, 2009

SOURCE: factory 99 dodge trailer plug wiring

You'll need to disconnect the wires from either the truck connector or the trailer connector...
I highly suggest purchasing a voltage checker- it looks like a screwdriver with a pigtail of wire with an alligator clip on the end. The tip of the 'screwdriver' has a point for probing. The light in the probe will light up...makes it easy to trouble shoot without a helper behind the trailer.
Hook the aligator clip to a good positive grounding point on the bumper or frame(not painted).
then pin by pin on the truck connection, stick the probe on each terminal tab.. and write a simple diagram where you find brake, tail, backup, etc...
Then i'd suggest, taking the connector off of your trailer, exposing the wire ends.
Run again thru your diagram and turn on each light of the truck. As you do, touch the wires from the trailer to that specific terminal. (make sure your ground wire is attached on the trailer) you can mark each wire with a piece of tape and label it which is which.
then simply attach your trailer wires according to your diagram to the terminals in the connector... that should get you in business..
hope that makes sense...
That way if the factory wiring harness remains the same, you'll be able to use it with other trailers if the need arises..

gordyh97

  • 4 Answers
  • Posted on Jun 10, 2009

SOURCE: No power to tail light on trailer- 2004 Dodge durango factory tow

If this is a factory light harness for the trailer hookup on your Caravan. Look under the hood for a fuse box. Many 2000+ vehicles have this with separate fuses just for the trailer lights.

Mike Tillman

  • 174 Answers
  • Posted on Oct 01, 2009

SOURCE: LEFT TRAILER TURN SIGNAL DOES NOT WORK

I have seen once before that the fuse box was bad on a 2003 Dodge 3500. I had power in and nothing out. We had to replace the box. Not cheap! Hope it is simple like a loose connection though. I think I had to pull the inner fender on the drivers side to access the bottom of the fuse box. Pain in the ****, but...

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

95 Dodge Dakota headlights, taillights dash lights suddenly went out. Have turn signals and flashers, no brake lights. Replace 15 amp fuse under dash that was blown nothing, replaced headlight switch

Did you check for voltage at the 50 amp fuse circuit. Even if the fuse is good if no voltage on the fuse circuit, the circuit is still dead. There is a light green wire that carries voltage from headlamp switch to dimmer, is that wire hot with headlamp switch on?

There are wiring diagrams for free, just about everywhere, if you don't have one. Autozone .com has free wiring diagrams on vehicle repair guides link. You have to register your vehicle, year--make--model, all that good stuff. It's free.
2helpful
2answers

Can't find fuse for tail lights. Not in cluster by steering wheel, not in cluster under hood.

the rear tail lights, license plate bulbs, and the front park lights are all fed off the same fuse. I show fuse one in the dash fuse block (15 amp). If the front amber park lights are working its not a fuse.

Are you sure the bulbs are good? Have you checked the connections in the harness?

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

0helpful
1answer

The dash lights are not working and the left rear

check the main fuse box under the hood,also check that the left front turn signal to see if the bulb is blown,sometimes when only one bulb is working it can cause it to flash much quicker,also check all the wiring there could be a short circuit somewhere ,this can also cause this problem.....hope this helps.....cheers
3helpful
2answers

How to fix gauges on 1997 dodge dakota truck

how do i remove the gauge face on a 2000 dakota
0helpful
2answers

97 dodge dakoata main fuse keeps blowing 140 amp fuse

Regulator in alternator obviously faulty, have it bench tested & fixed or replace alternator, and cure your problem.
2helpful
2answers

Dodge Dakota Battery still wont charge

I was running into this problem with my 97 5.2l Dakota and after some searching I found the the "Fuse Link" between the Alternator and the Battery was blow. Found a suitable "Fuse Link" at a local Auto parts store for about $5.
0helpful
1answer

Fuse blows on wiper when i start my 1999 dodge ram pickup

Hi my name is Allen!

When the fuse for the wipers keeps blowing, that means either the motor has a dead short within it and must be replaced, or the wiring going to the motor is damaged and shorting out on the vehicle body somewhere and must be repaired.

Here is how you check it; replace the blown fuse, unplug the connector from the wiper motor, then turn the key on if the fuse does not blow then you need to check the wiring to the motor if the wiring is not damaged anywhere replace the wiper motor.

For further assistance contact me at FixYa!
1helpful
1answer

1997 dodge dakota signal/hazard problem

This vehicle has what is known as a flasher unit, it is a relay assembly under the dash. This is the relay that clicks when your signals are on. it may need to be replaced. Another possible trouble spot could be the wiring in the steering column. Are there any other issues with horn, cruise etc.
Check the flasher first and get back to me.
Not finding what you are looking for?

115 views

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...