Drivers Information Center in a 2005 Chevy Impala

Fill the tires close to the max on sidewall & check the spare

If the light stays on ,go to a tire store,they will replace any bad
tpms sensor in a tire & explain how to reset

Most cars require a special tool,some don't,read owners manual

Temp fix is remove negative cable off battery for a few mins ,then replace,light might come back on but go to autozone have them do a code reader to tell what light means(if the code tells what is wrong)

Put air in whichever tire is low and the light should go off. Use a manual tire pressure gauge to find out which tire needs the air.

Hello
Your going to need to look at the placard in the drivers side door for recomennded air pressure.

Then put in the exact amount.You may need to drive 5 or 10 miles before it goes out.

I want to reset the low tire pressure light on my 2003 chevy impala. I go into the stereo disp. button, but the option is not there. How can reset it without using the stereo?

There should be a reset button in the fuse pannel. It can be used to reset the low tire pressure light , and the change oil light.
Instructions should be in owners manual , or you can google it.
Chevy dealership should do it for free in my opinion.

Your owners manual will give you a step by step proceedure for doing this.

the message center wants you to check air pressure in all of your tires,one or more is low on air.Once you find the one or more that is low you will have to reset that part of the computer.read in the owners manual under low tire pressure and it will tell you how to reset the computer.

remove the tyre valves and fit normal ones ,then the lights cant work and you have one less thing to worry about

If by low air air pressure, you mean the tire pressure sensor, here is the way to reset.
To reset (calibrate) the system: The tire pressure
monitor system can be reset two ways. With the ignition position at ON, pull the interior lamps control to the ON and OFF settings three times. It can also be reset through the radio using the
following steps:
1. Turn the ignition to ACC or ON and turn the radio off.
2. Press and hold the TUNE DlSP button on the radio for at least five seconds until SETTINGS is displayed.
3. Press the SEEK SCAN up or down arrow to scroll through the main menu.
4. Scroll until TIRE MON appears on the display.
5. Press the 1 PREV or 2 NEXT button to enter the submenu. RESET will be displayed.
6. Press the TUNE DlSP button to reset. A chime will be heard to verify the new setting and DONE will be displayed for one second.
7. Once the monitor has been reset, scroll until EXIT appears on the display.
8. Press the TUNE DlSP button to exit programming. A chime will be heard to verify exit.

The system completes the calibration process during
driving. The system normally takes 15 to 20 minutes of driving
in each of three speed ranges to "learn" tire pressures. The speed ranges are 15 to 40 mph (25 to 65 km/h), 40 to 65 mph (65 to 105 km/h) and above 65 mph (105 km/h). When learning is complete, the system will alert you after two to eight minutes if a tire is 12 psi (83 kPa) different from the other three tires. Detection thresholds may be higher and detection times may
be longer on rough roads, curves and at high speeds. The system is not capable of detection at speeds greater than 70 mph (110 km/h).

Almost all of the message center items are accessed through the menu on the radio. You should be able to find what you need be getting in the menu and looking around. Hope this is what you were looking for?