SOURCE: 1999 volvo s80 passenger seat stuck in forward position
you will need to check to make sure no coins fell into the track and is jammed it if not you will need to replace the bottom frame of the seat possible with a junk yard one much cheaper than buying new and junkyard frames come complete.
SOURCE: 1996 Volvo 960, Driver's motorized seat stuck
maybe you got pennies money stuck in the track if not you got 1 motor for that the motor goes in a assembly in there you have 2 cable a left and a right lock under the seat you probably got the right cale disconnect sometime there stuff that push under the seat and push that cable off if its that just push the cable back in let me know and please if you can take the time to rate this thank you pierre
p.s when you try to put the cable back in dont force to mush
PIERRE
SOURCE: rear passenger side seat belt
On my 96 I was able to lift the bottom of the seat enough to remove the lower seatbelt mount bolt, once the seat is up it will pull out. Sew a button where the original plastic disc was which prevents the seatbelt from retracting to far. Re-install bottom mount bolt.
SOURCE: Volvo '97 960 electric front
If you can hear the seat motor working, and the seat will not move back and is only affecting one side, there is a very good
chance that an object is resting in or on the seat rail, and is preventing the seat to move. You may have a coin stuck in the track, or possibly another small object. It may be difficult to see. I have seen this problem many times, and each time, there was always something blocking the seat movement....coins were number one.
Do you know what DTC'S - diagnostic trouble code's are ?
The driver and passenger seat heaters are controlled by the driver seat module. Power is supplied to the driver seat cushion and back heater elements through individual voltage supply circuits. Power is supplied to the passenger seat cushion and back heater elements through a common voltage supply circuit. All of the driver and passenger seat heater elements are grounded by the driver seat module through individual low side drive control circuits. The heater element control circuits are pulse width modulated to ground by the driver seat module in order to control the seat temperatures by regulating the current flow through the heater elements.
Your best bet , take it to a qualified repair shop that has diagnostic scanner that can read this code's
?€¢
DTC B2430 Passenger Seat Heater Circuit
Do you know what DTC'S - diagnostic trouble code's are ?
?€¢
DTC B2435 Driver Seat Back Heater Sensor Circuit
?€¢
DTC B2440 Passenger Seat Back Heater Sensor Circuit
The driver seat module relies on inputs from thermistors installed in the driver and passenger seat backs to control heated seat temperatures. The thermistors are 2-wire sensors supplied with a 5-volt referenced signal circuit and low reference circuit from the driver seat module. Resistance through the thermistors varies with temperature causing the heated seat sensor signal circuit voltage levels to decrease as the seat back temperatures rise.
165 views
Usually answered in minutes!
×