SOURCE: Where is the fuel pump resistor on a 1999 gtp?
It is in the fuse panel mounted under the hood near the overflow coolant bottle.
It is a square shaped device that is actually a relay, labeled with the number 2866.
SOURCE: replace headlight bulb
inside the engine compartment directly behind the headlight it unscrews and pops out. then put it back in and retighten.
SOURCE: Looking for rocker panels for 2000 pontiac grand
These rockers are also available at www.rustrepair.com - $8 UPS ground shipping if you mention you heard about them on fixya!
SOURCE: Location of mass air flow sensor, 2000 Grand Prix GTP
3.1 or 3.8 motor, mass air flow is in the fresh air (goes from air cleaner to engine)
SOURCE: how do you repair P0446 trouble code on a 2000
P0446 - Evaporative Emmission Control System Vent Control Circuit
Evap vent valve has only one purpose. It closes in order to seal the vent so the EVAP system can pressurize and ensure there are no leaks. Evap vent valve is usually supplied Batt. voltage with key on. The ECM's driver controls the ground, and when grounded, activates the valve (closing it). If the ECM detects a short to ground, and open,or a short to battery voltage on the control circuit, P0446 will set. Code also may refer to ECM detecting that EVAP system is unable to achieve or maintain vacuum during test.
Symptoms: There will be no obvious symptoms to driver, other than MIL illumination.
Causes: A code P0446 could mean one or more of the following has happened:
* Faulty vent valve
* Open, short or excessive resistance on Vent valve control circuit
* Blockage of vent valve
* Bad PCM
Possible Solutions: With a P0446 OBD-II trouble code, here are some things to try:
* Replace Vent valve
* Repair open, short, or resistance problem in control circuit
* Repair open, or short, or resistance problem in power circuit
* Replace PCM
Review this information, Test it and tell us news.
156 views
Usually answered in minutes!
×