Where is a body control module located on the bravada my driver window works but the other three won't roll down with the indivdual switches

There is no BODY CONTROL module,but there is a Front Electronic module FEM, and a rear electronic module,REM (not the rock group,LOL!).
The FEM is located behind the driver's kick panel and the FEM is located on the right side down in the trunk.
The REM controls: Rear windows, , all rear lights, trunk opening, fuel door release, rear window defrost grid, trunk ajar switch, front passenger door lock, , front passenger door lock switch,rear door locks, trunk light, fuel pump, fuel level senders, antenna booster.

Hope this helps? don-ohio (:^)

The BCM is located under the rear seat on driver's side next to fuse box.
Don't believe this is a BCM problem, it is more likely the Driver's Door Module itself. Try moving the passenger door module over to the driver's side and see if that works the windows.

change master switch first!

The power windows on your vehicle are controlled by an electronic control module , as are the power mirrors !
Power Window System Components
The power window system consists of the following components:
• Driver door module (DDM)
• Passenger door module (PDM)
• Body control module (BCM)
• LR power window switch
• RR power window switch
• Window up and window down relays in each of the rear passenger window switches
• Window lockout switch
• Reversible power window motors in each of the doors (circuit breaker protected)
• LT DOOR CB 25A (System power for left rear window)
• RT DOOR CB 25A (System power for right rear window)

Your best bet , take your vehicle to a qualified repair shop.

body contol module problem find a shop you can trust a used bcm can be installed but then you have the problem of the radio not receiving the vin number from the control module so you still have a problem with the radio buy the radio and bcm used from salvage and go through the mechanic to purchase it. I know my mechanic paid 65 dollars for the bcm 2002 buick rendevous and the salvage will sell me the radio that matches for another 65 and my mechanic charged me 125 diagnostic plus time to install be prepared for a lighter wallet.

Given the amount of electronic's ( computers ) on your vehicle ,it could be a lot of thing's . Hooking up a factory or professional grade scan tool that can communicate with all the control modules on the vehicle should be the first step in the diagnostic problem . Checking for DTC'S - diagnostic trouble codes , communication between module errors etc.....
Your best bet , take it to a qualified repair shop that has the proper diagnostic equipment to check it out .
The power door lock system consists of the following components:
• Body control module (BCM)
• Driver door lock switch
• Front passenger door lock switch
• Door lock actuators in each of the doors
• Door lock system fuse into the BCM (BCM D 25A fuse)

BCM Functions
The body control module (BCM) is capable of accomplishing multiple body control functions. Components directly connected to the BCM are controlled by the BCM outputs. The BCM can control its outputs based on input information it obtains from sensors and switches that are directly connected to the BCM, or by receiving information from other vehicle systems connected to the class 2 serial data link. The BCM evaluates this information and controls certain body systems by commanding an output on or off.
The BCM is also capable of commanding other vehicle systems to control functions that are not directly wired to and/or controlled by the BCM. The BCM accomplishes this task by sending specific messages on the class 2 serial data link. The vehicle system capable of performing such function will respond to the BCM message.
The BCM controls/monitors the following functions:
• Audible warnings
• Indicators control
• Interior lighting
• Exterior lighting
• Power/automatic door locks
• Keyless entry
• Content theft deterrent
• Personalization
• Serial Power Modes
• Electrical Power Management

Buick Class 2 Operation Diagnosis 1998

Hi

The door control module actually consists of the door's Electronic Control Unit (ECU) and the switches or buttons integrated into one assembly. There are two of them: the driver door module or DDM (as seen on the sample diagram below) and the passenger door module or PDM, which is on the right front door. These modules are programmable.
They are also called driver door switch (DDS) and passenger door switch (PDS), so perhaps you can rephrase your search.

Please check this links to get some useful information:-

http://www.2carpros.com/articles/test-or-change-electric-power-door-locks

also check the picture attached:-

Please get back to us if you have further query or else please accept the solution.

The power locks have absolutely nothing to do with the power windows - totally different circuits.

The FIRST thing to check is to make sure that the window lockout button on the driver's door control switch is not turned on. This will keep all of the windows from operating except the driver's window.

Other than that, there are several things that can cause a power window to not roll down. It can be a power window lift motor, a window regulator, the window switches, or any of the wiring in between. Also, you did not mention which window is not working. BOTH of the FRONT windows are equipped with Door Control Modules (DCM) which, in turn, are controlled by the Body Control Module (BCM). If it is the front window you are talking about, it will be necessary to scan your BCM for fault codes to determine the source of the problem. If it is one of the rear windows, this can be checked by regular electrical testing and a scanner should not be necessary.

Wow! Sounds like multiple problems but the back window popping open is probably the Body Control Module. Could be loosing ground at the body straps or positive from the battery cable connections during cranking?

be careful with jeeps they have a body control module that controls the windows , locks ect they go out often a dealer with scanner can check. also you have the window switch on the drivers door , rarely is it the regulator on a jeep