Inside latch won't open door but outside works fine

I see you are ale to see the cables and rods how and when they operate. When you to open the latch from the outside and the inside. Are you able to see if they move the mechanism up or down as you try to open the door working the latch outside and the inside door handle. Sounds like your door latch broke internally, the only thing I was able to do was from the inside with somebody holding the outside latch up to open. Kick it hard in the area where the door latch is. Lay on the sit and kick it hard while the outside individual lifts the latch and pulls. It should pop open. Good luck.

If the little lever on the door latch doesn't work, you will need a new door latch.

The hadle may have broke but more likely the clip holding the linkage to the leaver has come off. you will need to pull door panel off

Remove the door trim and reattach the rod/ lever that has come out of the fitting of the latch.

Ask the CAA or AAA to open it, they have the tool, and experience

It can be faulty switch or safety lock enabled.Go through this direct link and follow the step by step process to get the door open from inside:

Click the ;link:--

http://www.howtorepairguide.com/2013/02/honda-pilot-rear-door-lock-wont-open.html

---------

This will help.

Thanks.

your door rod to your latch must have popped off your inside door latch. take your door pannel off and the door rood will be unhooked

Probably the lock in the latch.
You'll have to remove the inside door panel to get to the latch.

My friend just had this problem and he reached in and pulled the inside door handle back as far as it would go, and then let it go, allowing it to 'snap' back. For some reason this fixed it. We have no idea why. By doing this on one door, both rear door locks freed up and the rear locks are now working. Before, both rear locks were stuck and you could not open the doors from the inside nor the outside. Not sure why it works, but maybe it will work for you!

There is a rod inside the door that connects the inside and outside door handles to the latch mechanism, if it gets bent or broke it won't activate the latch. The inside door panel will have to be removed and parts of the mechanism also to reinstall. Would recommend maybe taking somewhere unless it's an old BWM.