Can i buy just the lower seat section for an 08 tundra. Grey color. has burn hole in it. would like to replace just the section that you sit on, not the whole seat.

You need to remove the seat bottom first to access the lower attaching points.

Here's a video on installing seat covers for your Tundra, 07 13 Toyota Tundra factory seat covers installed I had a 2004 Tundra,bought seat covers from Dealer and installed,real easy.I had leather seats.Here's a video of my Tundra I sold,you will see the seat covers,cause I show them. 04 TOYOTA TUNDRA SR5 TRD THE DESERT SAND WALK THRU

ck tuotube

its nothing to be concerned about, as long as its not grey or blue color. grey color smoke means that you are burning engine oil, watch your oil consumption, you may need to replace your valve guide seal or your piston ring may be worned out. it could also be your transmission fluid could be burning in the engine. I hope this helps, good luck to you.

disconnect the battery and take up the rear seat... the lower part that u sit on... theres a little access hole there... disconnect the lines, unplug the plug and take the nuts off... pull the pump out and replace...

Please don't forget to rate!

1. Before servicing the vehicle, refer to the Precautions section.
   

1. Remove or disconnect the following:
2. Front wheel
   

• Strut-to-lower control arm nut/bolt and the strut
  
• Strut-to-chassis nuts/bolts and the strut
  

Lower control arm Tundra

To install:

1. Install or connect the following:
   
   • Strut to the chassis. Torque the nuts/bolts to 33 ft. lbs. (45 Nm).
     
   • Strut to the lower control arm. Torque the nut/bolt to 144 ft. lbs. (195 Nm).
     
   • Front wheel
     

// // 0) preLoad.src = ctl00_cphLeft_chRepairTreeNav_tvTOC_ImageArray[i]; } ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.lastIndex = 31; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.populateLog = theForm.elements['ctl00_cphLeft_chRepairTreeNav_tvTOC_PopulateLog']; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.treeViewID = 'ctl00$cphLeft$chRepairTreeNav$tvTOC'; ctl00_cphLeft_chRepairTreeNav_tvTOC_Data.name = 'ctl00_cphLeft_chRepairTreeNav_tvTOC_Data'; //]]> var _strTreeScrollHidName = 'ctl00_hidTreeScrollPos';

An option for you to consider is buying a used seat. It might be cheaper, easier to find, and easier to replace than trying to find parts for your seat then paying labor to remove the seat, disassemble the seat, replace the part, and put it all back together.

There are many of these cars on the road and the used seat should be pretty easy to find. You will probably get lucky and find one the same color, with the same options, and possibly better overall condition than your current seat.

Any local auto salvage/recycling yard should be able to help you out.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

clock wise should pull light up. counter clock wise should tilt down

There is no way to do this without buying a programmer.

try the fuse box,and see if theres a specific fuse for that,or if you want to be a mcguiver,lol maybe put a piece of metal to replace the seat belt. good luck.