I have a gwm steed 2.8 tdi. my power dissapears once the vehicle is at running temp. i dont believe it is dirty diesel or a service issue. this has been checked. does anyone have an idea what it could be.

I would check the fuel pressure. At the injectors you should see 2000 - 2500 lb/square inch

The location of the injector relay on your 2008 GWM Steed 2.2 Bakkie may vary depending on the specific model and trim level of your vehicle.
Here are a few steps you can take to locate the injector relay on your GWM Steed 2.2 Bakkie:

1. Check the owner's manual: The owner's manual for your vehicle should have a diagram of the engine compartment and the location of all the relays, including the injector relay.
2. Check the engine compartment: The injector relay is usually located in the engine compartment near the battery, fuse box, or engine control module. It is a small box with several relays inside.
3. Check the relay box: The relay box is usually located under the hood, near the firewall, or on the driver's side fender.
4. Consult a mechanic: If you are unable to find the injector relay, it may be best to consult a professional mechanic or a GWM dealer for further assistance.

It's also worth noting that, when you say there is no power on your injectors, it could be a symptom of a different problem. It could be a problem with the wiring or the control module, a problem with the battery, or a problem with the alternator. So it is best to get it checked by a professional.

Question edited for clarity.

This is a solely South African vehicle. You always need to specify the torque settings for the part, otherwise search results give to the torque the engine produces. This search query is for 'cylinder head torque'. Your results will be better than mine here in North America.

https://www.google.com/search?q=GWM+Steed+5+2.0+vgt+diesel%2C+cylinder+head+bolt+torque

..

They tend to be shown in sections on Google. for the full wiring diagram, you would need to purchase a Service Manual.

https://www.google.com/search?q=wiring+diagram+for+the+GWM+Steed+2.2+Doublecab

..

search-- reviews for GWM steed 5

.010" inlet hot and .012" exhaust hot

gap should be 0.8mm

Hi everyone, I'm looking for diagram or manual photos of GWM 2008 Model with a GW2.8TC-2 diesel engine, for front timing cover marks of camshaft and diesel pump. I bought the vehicle with disassembled engine and the injector wires were tempered with. So I also need to know how to identify which one to plug on cylinder number 1 till 4th cylinder.
Any help will be appreciated. Email me the diagrams to [email protected] (Att : Piet)

It sounds like the steering rack is leaking pressure internally.

I have the same problem few days ago, and still didn't find any solution. Can any one please help?????19