SOURCE: how to remove the crankshaft harmonic balancer on
National fine thread, regular right hand. You may need a puller to remove damper after removing bolt.
SOURCE: crankshaft pulley
no it doesnt,to undo fit a appropiate socket and using a big knuckle bar wedged in suspension turn starter motor to undoo the bolt
SOURCE: 97 neon speedometer guage and crankshaft threads
pls take your car to the nearest service center, check the speedometer cable installed..it should have either been destroyed or it should have a loose contact..for second problem ask the service personnel to check the connections are tight enough with preferred torque
SOURCE: does the crankshaft pulley bolt have reversed
No, standard thread. Turn anticlockwise to undo. That bolt will be VERY tight, and make sure it is done up VERY tight when you put it back together. I recommend a drop of thread lock to avoid it coming loose later on. This bolt doesn't need to be removed to change the timing belt, but it does if you want to change the front crank seal.
SOURCE: removal of bolt on front of crank shaft to replace
you need a chain or strap wrench to hold crankshaft drive sprocket to loosen crankshaft bolt.
Fig. 3: Do not attempt to pry on the damper to remove it from the crankshaft, use a puller only
Fig. 4: Removing the damper from the crankshaft
Fig. 5: When installing the damper, thread the bolt by hand first to prevent cross-threading
187 views
Usually answered in minutes!
×