Its easy realy,,but,,,only change one plug and one lead at a time,,
that way you cant mess up ,,can you?
SOURCE: Spark plug to distributor cap Wiring schematic for
I'm guessing that you have the 6 cyl 2.5 liter engine because the 2.4 liter engine that the Cirrus had for that year I believe had a coil pack. The picture below is for the 2.5. If you need the other just write a reply and I will be notified in my email and I will post it if needed. I hope this helps you and good luck.
SOURCE: how do you replace spark plugs on a 1996 chrysler
You will have to remove the upper intake manifold to replace the rear plug.There are no shortcuts ,and besure to replace the upper intake gasket as well.
SOURCE: how do I change the
I did a Google search "How do you replace the rear spark plugs on a 2000 Chrysler Cirrus?" and found this link: http://www.faqs.org/qa/qa-6243.html
I haven't tried it yet and am thinking of purchasing a Chilton manual just in case, but as far as explanations go the one at the very bottom of the page in the link sounds the most legitimate so far.
Besides, I have to pay you guys $9.99 for one answer that I can get for free; or I can get the Chilton and have a whole heap of answers for around $20.
SOURCE: 1999 chrysler cirrus
Check the coil packs, or the Ignition module. Disconnect the harness to the ignition module. And test the leads to see if there is current. I don't know what the specs should be, but it will be minimal. Never overlook fuses either.
2,862 views
Usually answered in minutes!
×