Headlight bulb replacement for 2007 saturn outlook?

dont think you can on this car ,you need to replace the headlights complete

Hi Carol , your going to have to remove the headlamp assembly to replace the bulb !


Remove the headlamp assembly. Refer to Headlamp Replacement.



1



Headlamp Bulb Accessory Covers (Qty: 2)



2



Headlamp Bulb Assembly (High Beam)




Caution: Refer to Halogen Bulb Caution in the Preface section.




Tip

Disconnect the electrical connectors and remove the bulbs.



3



Headlamp Bulb Assembly (Low Beam)


Callout

Component Name

Preliminary Procedure

Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement .




Headlamp Assembly Bolt (Qty: 4)

Notice: Refer to Fastener Notice in the Preface section.

Tighten

6 N?·m (53 lb in)







2





Headlamp Fascia Brace Fender Reinforcement Bolt




Tighten

6 N?·m (53 lb in)







3





Headlamp Cam Adjuster




Procedure

Set the headlamp adjusters at the nominal setting of 6 turns off fully seated.







4





Headlamp Cam Locking Nut







5





Headlamp Assembly




Tip

Disconnect the electrical harness as the headlamp assembly is being removed from the vehicle.

i found that you can reach it bye on screwing the fourr 8m bots that hold the inner wheel weld. Once you remove the bolts just pull inner plastic fender away and you will be able to unscrew the outer retainer cup then unscrew bulb housing..

I have an Outlook that was burning through bulbs. The best way to change it, is to remove the inner fender well and it gives you easy access to the rear of the headlight assembly. It takes about 2 min and no skinny hands required.

I was able to replace this bulb via the wheel well. There were 4 small screws holding the liner on. I was then able to bend the liner back + turn the light bulb dust cover and remove it. The bulb assembly also had to be turned to pull it out. I then removed the wireplug. My bulb was intact + the wire connecting to the bulb was the problem. I simply brushed off some of the carbon residue from the wireset overheating. Then reattached it which worked long enough to buy a new wireset. I am very disapointed I had to do this basic repair on my fairly new outlook 500 miles out of a 36k warranty

This has to be done by pulling the bumper off. More then likely there will be a burned up harness (recurring problem with the 2008 Saturn Outlook) the cost from my Saturn dealership is $185.00 to replace the harness and bulb. Very poor engineering when you have to pay $185.00 to change a bulb.

from the bach, remove small cover then unplug connector, there should be a clip or a round holder twist holding ring in the counterclock wise direction and remove then plug back and light should come rite out,hope this helps.

actually according to saturn you must remove the front bumper to remove the headlight to be able to replace the bulb,,,if you got small hand you can remove the front part of the inner fender liner and go up thru there and do it,you cant see it ,, you gotta feel it,yes dumb idea i agree,i gotta work on them all day

I agree with the other fae90. Tried to remove the light assy, then I read his post and did it inside 20 minutes. Took me longer to put it all back again

Best method that I found is to just take the 6 phillips screws (4 in the well and 2 below the front bumper cover) out of the forward wheel well panel and reach in behind the panel to the headlight assembly.