SOURCE: 1998 dodge avenger tranmission control solenoid
Below the link for Chrysler/Dodge auto-transmission manual
http://www.scribd.com/doc/7095618/545rfe-Transmission-Manual
Solenoid mounts outside the transmission, so you do not need to remove the transmission to install. It should be located between fuse box and air filter housing on the top of transaxle case and right next to transmission controle module.
I hope his step by step procedure will work for you. It is not hard at all to replace the solenoid. There are three 10mm bolts. You will also need to remove the input speed sensor. One thing to look out for is not bending the gasket when installing the new solenoid:
Keep everything clean to prevent foreign materials to go inside
P.s. 1. You can fine some clips on YouTube.com at least for similar cars
2. Also at Autozone.com you can find the component location for your car and repair guide
3. Also there is a link for Mitchel1 online manual useb by US mechanic 1 week subscribtion is
11.99 , 1 month 16.99
http://www.2carpros.com/kpages/auto_repair_manuals.htm
Let me know if you need more info
Good Luck and happy fixing
SOURCE: I have a 96' Dodge Neon, and my car wont start!
Check the timing belt. Sometimes the timing tentioner goes bad in them.
SOURCE: My dodge avenger doesnt start, i replaced rotor
you also have a coil and a ignition module that could be keeping you from getting spark. also there needs to be a trigger to fire the system usually a crank sensor have seen it run from a cam sensor though
SOURCE: Cam sensor causing other probelems
the cam sensor definitly can cause the problem. pull the trouble code and make sure the check engine light is for the cam sensor. if so, replace it and retest
71 views
Usually answered in minutes!
×